[dpdk-dev] VMDq + DCB: 128 Tx queues

Liu, Jijiang jijiang.liu at intel.com
Fri Aug 1 09:41:20 CEST 2014


Yes, if you hope TX is configured DCB mode, and 128 TX queues are needed. In testpmd codes, there is an example how to use 128 RX queue and 128 TX queue simultaneously in vmdq+dcb mode.
The example function is get_eth_dcb_conf() in testpmd.c file.

BRs,
Jijiang Liu

-----Original Message-----
From: dev [mailto:dev-bounces at dpdk.org] On Behalf Of Sunil Bojanapally
Sent: Friday, August 01, 2014 1:13 PM
To: dev at dpdk.org
Subject: [dpdk-dev] VMDq + DCB: 128 Tx queues

Hi team,

As per dpdk programming guide on VMDq+DCB will configure each Ethernet port to 16 pools with 8 queues each. Which means per port will have 128 Rx & Tx queues.

The question is, in order to have end 2 end QoS support the port should get configured with 128 Rx as well as 128 Tx queues ?

Note: I am considering same port for Rx & Tx.

Thanks,
Sunil



More information about the dev mailing list