[dpdk-dev] [PATCH v4] mbuf: fix of enabling all newly added RX error flags

[Thomas Monjalon]

2014-12-10 16:55, Helin Zhang:
> Before redefining mbuf structure, there was lack of free bits in 'ol_flags'
> (32 bits in total) for new RX or TX flags. So it tried to reuse existant
> bits as most as possible, or even assigning 0 to some of bit flags. After
> new mbuf structure defined, there are quite a lot of free bits. So those
> newly added bit flags should be assigned with correct and valid bit values,
> and getting their names should be enabled as well. Note that 'RECIP' should
> be removed, as nowhere uses it. 'PKT_RX_ERR' is defined to replace all other
> error bit flags, e.g. MAC error, Oversize error, header buffer overflow error.
> 
> Signed-off-by: Helin Zhang <helin.zhang at intel.com>
> ---
>  lib/librte_mbuf/rte_mbuf.c      |  7 ++-----
>  lib/librte_mbuf/rte_mbuf.h      |  9 +++------
>  lib/librte_pmd_i40e/i40e_rxtx.c | 37 ++++++++++++++++++++-----------------
>  3 files changed, 25 insertions(+), 28 deletions(-)
> 
> v2 changes:
> * Removed error flag of 'ECIPE' processing only in both i40e PMD and mbuf. All
>   other error flags were added back.
> * Assigned error flags with correct and valid values, as their previous values
>   were invalid.
> * Enabled getting all error flag names.
> 
> v3 changes:
> * 'PKT_RX_ERR' is defined to replace error bit flags of MAC error, Oversize
>   error, header buffer overflow error.
> * Removed assigning values to PKT_TX_* bit flags, as it has already been done
>   in another packet set.
> 
> v4 changes:
> * Renamed 'PKT_RX_EIP_CKSUM_BAD' to 'PKT_RX_OUTER_IP_CKSUM_BAD'.
> * Fixed the bug of checking error bits of 'Descriptor oversize' and
>   'Header buffer oversize'.
> * Added debug logs for each RX error.
[...]
> --- a/lib/librte_mbuf/rte_mbuf.h
> +++ b/lib/librte_mbuf/rte_mbuf.h
> @@ -83,12 +83,7 @@ extern "C" {
>  #define PKT_RX_RSS_HASH      (1ULL << 1)  /**< RX packet with RSS hash result. */
>  #define PKT_RX_FDIR          (1ULL << 2)  /**< RX packet with FDIR match indicate. */
>  #define PKT_RX_L4_CKSUM_BAD  (1ULL << 3)  /**< L4 cksum of RX pkt. is not OK. */
> -#define PKT_RX_IP_CKSUM_BAD  (1ULL << 4)  /**< IP cksum of RX pkt. is not OK. */
> -#define PKT_RX_EIP_CKSUM_BAD (0ULL << 0)  /**< External IP header checksum error. */
> -#define PKT_RX_OVERSIZE      (0ULL << 0)  /**< Num of desc of an RX pkt oversize. */
> -#define PKT_RX_HBUF_OVERFLOW (0ULL << 0)  /**< Header buffer overflow. */
> -#define PKT_RX_RECIP_ERR     (0ULL << 0)  /**< Hardware processing error. */
> -#define PKT_RX_MAC_ERR       (0ULL << 0)  /**< MAC error. */
> +#define PKT_RX_IP_CKSUM_BAD  (1ULL << 4)  /**< IP (or inner IP) header checksum error. */

It can be also an outer IP header in case the device don't support
tunneling or is not configured to detect it.
-- 
Thomas

>  #define PKT_RX_IPV4_HDR      (1ULL << 5)  /**< RX packet with IPv4 header. */
>  #define PKT_RX_IPV4_HDR_EXT  (1ULL << 6)  /**< RX packet with extended IPv4 header. */
>  #define PKT_RX_IPV6_HDR      (1ULL << 7)  /**< RX packet with IPv6 header. */
> @@ -99,6 +94,8 @@ extern "C" {
>  #define PKT_RX_TUNNEL_IPV6_HDR (1ULL << 12) /**< RX tunnel packet with IPv6 header. */
>  #define PKT_RX_FDIR_ID       (1ULL << 13) /**< FD id reported if FDIR match. */
>  #define PKT_RX_FDIR_FLX      (1ULL << 14) /**< Flexible bytes reported if FDIR match. */
> +#define PKT_RX_OUTER_IP_CKSUM_BAD (1ULL << 15)  /**< Outer IP header checksum error. */
> +#define PKT_RX_ERR           (1ULL << 16)  /**< Other errors, e.g. MAC error. */
>  /* add new RX flags here */
>  
>  /* add new TX flags here */