[dpdk-dev] Rx-errors with testpmd (only 75% line rate)

Wang, Shawn xingbow at amazon.com
Wed Jan 22 18:46:14 CET 2014


Does your NIC connect directly to your Socket?
If not, the packet might go through QPI, which will cause additional
latency.
Check your motherboard.

Wang, Shawn




On 1/22/14, 6:52 AM, "Dmitry Vyal" <dmitryvyal at gmail.com> wrote:

>Hello MIchael,
>
>I suggest you to check average burst sizes on receive queues. Looks like
>I stumbled upon a similar issue several times. If you are calling
>rte_eth_rx_burst too frequently, NIC begins losing packets no matter how
>many CPU horse power you have (more you have, more it loses, actually).
>In my case this situation occured when average burst size is less than
>20 packets or so. I'm not sure what's the reason for this behavior, but
>I observed it on several applications on Intel 82599 10Gb cards.
>
>Regards, Dmitry
>
>
>On 01/09/2014 11:28 PM, Michael Quicquaro wrote:
>> Hello,
>> My hardware is a Dell PowerEdge R820:
>> 4x Intel Xeon E5-4620 2.20GHz 8 core
>> 16GB RDIMM 1333 MHz Dual Rank, x4 - Quantity 16
>> Intel X520 DP 10Gb DA/SFP+
>>
>> So in summary 32 cores @ 2.20GHz and 256GB RAM
>>
>> ... plenty of horsepower.
>>
>> I've reserved 16 1GB Hugepages
>>
>> I am configuring only one interface and using testpmd in rx_only mode to
>> first see if I can receive at line rate.
>>
>> I am generating traffic on a different system which is running the
>>netmap
>> pkt-gen program - generating 64 byte packets at close to line rate.
>>
>> I am only able to receive approx. 75% of line rate and I see the
>>Rx-errors
>> in the port stats going up proportionally.
>> I have verified that all receive queues are being used, but strangely
>> enough, it doesn't matter how many queues more than 2 that I use, the
>> throughput is the same.  I have verified with 'mpstat -P ALL' that all
>> specified cores are used.  The utilization of each core is only roughly
>>25%.
>>
>> Here is my command line:
>> testpmd -c 0xffffffff -n 4 -- --nb-ports=1 --coremask=0xfffffffe
>> --nb-cores=8 --rxd=2048 --txd=2048 --mbcache=512 --burst=512 --rxq=8
>> --txq=8 --interactive
>>
>> What can I do to trace down this problem?  It seems very similar to a
>> thread on this list back in May titled "Best example for showing
>> throughput?" where no resolution was ever mentioned in the thread.
>>
>> Thanks for any help.
>> - Michael
>



More information about the dev mailing list