[dpdk-dev] [PATCH] rte_ethdev: whitespace cleanup
Stephen Hemminger
stephen at networkplumber.org
Mon Aug 10 20:10:21 CEST 2015
From: Stephen Hemminger <shemming at brocade.com>
Cleanup whitespace and other trivial warnings from checkpatch.
Signed-off-by: Stephen Hemminger <stephen at networkplumber.org>
---
lib/librte_ether/rte_ethdev.h | 54 +++++++++++++++++++++----------------------
1 file changed, 27 insertions(+), 27 deletions(-)
diff --git a/lib/librte_ether/rte_ethdev.h b/lib/librte_ether/rte_ethdev.h
index 544afe0..b2ff337 100644
--- a/lib/librte_ether/rte_ethdev.h
+++ b/lib/librte_ether/rte_ethdev.h
@@ -244,7 +244,7 @@ struct rte_eth_link {
uint16_t link_speed; /**< ETH_LINK_SPEED_[10, 100, 1000, 10000] */
uint16_t link_duplex; /**< ETH_LINK_[HALF_DUPLEX, FULL_DUPLEX] */
uint8_t link_status : 1; /**< 1 -> link up, 0 -> link down */
-}__attribute__((aligned(8))); /**< aligned for atomic64 read/write */
+} __attribute__((aligned(8))); /**< aligned for atomic64 read/write */
#define ETH_LINK_SPEED_AUTONEG 0 /**< Auto-negotiate link speed. */
#define ETH_LINK_SPEED_10 10 /**< 10 megabits/second. */
@@ -746,7 +746,7 @@ enum rte_l4type {
*/
enum rte_iptype {
RTE_FDIR_IPTYPE_IPV4 = 0, /**< IPv4. */
- RTE_FDIR_IPTYPE_IPV6 , /**< IPv6. */
+ RTE_FDIR_IPTYPE_IPV6, /**< IPv6. */
};
/**
@@ -864,7 +864,7 @@ struct rte_eth_conf {
struct rte_eth_rxmode rxmode; /**< Port RX configuration. */
struct rte_eth_txmode txmode; /**< Port TX configuration. */
uint32_t lpbk_mode; /**< Loopback operation mode. By default the value
- is 0, meaning the loopback mode is disabled.
+ is 0, meaning the loopback mode is disabled.
Read the datasheet of given ethernet controller
for details. The possible values of this field
are defined in implementation of each driver. */
@@ -1454,15 +1454,15 @@ struct eth_dev_ops {
/**< Set eeprom */
/* bypass control */
#ifdef RTE_NIC_BYPASS
- bypass_init_t bypass_init;
- bypass_state_set_t bypass_state_set;
- bypass_state_show_t bypass_state_show;
- bypass_event_set_t bypass_event_set;
- bypass_event_show_t bypass_event_show;
- bypass_wd_timeout_set_t bypass_wd_timeout_set;
- bypass_wd_timeout_show_t bypass_wd_timeout_show;
- bypass_ver_show_t bypass_ver_show;
- bypass_wd_reset_t bypass_wd_reset;
+ bypass_init_t bypass_init;
+ bypass_state_set_t bypass_state_set;
+ bypass_state_show_t bypass_state_show;
+ bypass_event_set_t bypass_event_set;
+ bypass_event_show_t bypass_event_show;
+ bypass_wd_timeout_set_t bypass_wd_timeout_set;
+ bypass_wd_timeout_show_t bypass_wd_timeout_show;
+ bypass_ver_show_t bypass_ver_show;
+ bypass_wd_reset_t bypass_wd_reset;
#endif
/** Configure RSS hash protocols. */
@@ -1628,10 +1628,10 @@ struct rte_eth_dev_data {
/**< Common rx buffer size handled by all queues */
uint64_t rx_mbuf_alloc_failed; /**< RX ring mbuf allocation failures. */
- struct ether_addr* mac_addrs;/**< Device Ethernet Link address. */
+ struct ether_addr *mac_addrs; /**< Device Ethernet Link address. */
uint64_t mac_pool_sel[ETH_NUM_RECEIVE_MAC_ADDR];
/** bitmap array of associating Ethernet MAC addresses to pools */
- struct ether_addr* hash_mac_addrs;
+ struct ether_addr *hash_mac_addrs;
/** Device Ethernet MAC addresses of hash filtering. */
uint8_t port_id; /**< Device [external] port identifier. */
uint8_t promiscuous : 1, /**< RX promiscuous mode ON(1) / OFF(0). */
@@ -2342,7 +2342,7 @@ extern int rte_eth_dev_set_mtu(uint8_t port_id, uint16_t mtu);
* - (-ENOSYS) if VLAN filtering on *port_id* disabled.
* - (-EINVAL) if *vlan_id* > 4095.
*/
-extern int rte_eth_dev_vlan_filter(uint8_t port_id, uint16_t vlan_id , int on);
+extern int rte_eth_dev_vlan_filter(uint8_t port_id, uint16_t vlan_id, int on);
/**
* Enable/Disable hardware VLAN Strip by a rx queue of an Ethernet device.
@@ -2563,10 +2563,10 @@ extern uint32_t rte_eth_rx_queue_count(uint8_t port_id, uint16_t queue_id);
static inline uint32_t
rte_eth_rx_queue_count(uint8_t port_id, uint16_t queue_id)
{
- struct rte_eth_dev *dev;
+ struct rte_eth_dev *dev;
- dev = &rte_eth_devices[port_id];
- return (*dev->dev_ops->rx_queue_count)(dev, queue_id);
+ dev = &rte_eth_devices[port_id];
+ return (*dev->dev_ops->rx_queue_count)(dev, queue_id);
}
#endif
@@ -2595,8 +2595,8 @@ rte_eth_rx_descriptor_done(uint8_t port_id, uint16_t queue_id, uint16_t offset)
struct rte_eth_dev *dev;
dev = &rte_eth_devices[port_id];
- return (*dev->dev_ops->rx_descriptor_done)( \
- dev->data->rx_queues[queue_id], offset);
+ return (*dev->dev_ops->rx_descriptor_done)
+ (dev->data->rx_queues[queue_id], offset);
}
#endif
@@ -2911,8 +2911,8 @@ enum rte_eth_event_type {
RTE_ETH_EVENT_MAX /**< max value of this enum */
};
-typedef void (*rte_eth_dev_cb_fn)(uint8_t port_id, \
- enum rte_eth_event_type event, void *cb_arg);
+typedef void (*rte_eth_dev_cb_fn)(uint8_t port_id,
+ enum rte_eth_event_type event, void *cb_arg);
/**< user application callback to be registered for interrupts */
@@ -3246,8 +3246,8 @@ int rte_eth_dev_rss_reta_query(uint8_t port,
* - (-ENODEV) if *port_id* invalid.
* - (-EINVAL) if bad parameter.
*/
-int rte_eth_dev_uc_hash_table_set(uint8_t port,struct ether_addr *addr,
- uint8_t on);
+int rte_eth_dev_uc_hash_table_set(uint8_t port, struct ether_addr *addr,
+ uint8_t on);
/**
* Updates all unicast hash bitmaps for receiving packet with any Unicast
@@ -3266,7 +3266,7 @@ int rte_eth_dev_uc_hash_table_set(uint8_t port,struct ether_addr *addr,
* - (-ENODEV) if *port_id* invalid.
* - (-EINVAL) if bad parameter.
*/
-int rte_eth_dev_uc_all_hash_table_set(uint8_t port,uint8_t on);
+int rte_eth_dev_uc_all_hash_table_set(uint8_t port, uint8_t on);
/**
* Set RX L2 Filtering mode of a VF of an Ethernet device.
@@ -3310,7 +3310,7 @@ int rte_eth_dev_set_vf_rxmode(uint8_t port, uint16_t vf, uint16_t rx_mode,
* - (-EINVAL) if bad parameter.
*/
int
-rte_eth_dev_set_vf_tx(uint8_t port,uint16_t vf, uint8_t on);
+rte_eth_dev_set_vf_tx(uint8_t port, uint16_t vf, uint8_t on);
/**
* Enable or disable a VF traffic receive of an Ethernet device.
@@ -3329,7 +3329,7 @@ rte_eth_dev_set_vf_tx(uint8_t port,uint16_t vf, uint8_t on);
* - (-EINVAL) if bad parameter.
*/
int
-rte_eth_dev_set_vf_rx(uint8_t port,uint16_t vf, uint8_t on);
+rte_eth_dev_set_vf_rx(uint8_t port, uint16_t vf, uint8_t on);
/**
* Enable/Disable hardware VF VLAN filtering by an Ethernet device of
--
2.1.4
More information about the dev
mailing list