[dpdk-dev] [PATCH] bnx2x: always reinitialize the rx queue indices

[Chas Williams]

If you stop and start the driver, the rx queue will have the previous
index values when programming the adapter.  Therefore, we should always
reset the queue indices when the rx ring is setup.  Note:  We need to
clear (write) the status block's completion queue index since it is
possibly in a read cache.

Tidy some init code to make it clearer what the defaults are.

Signed-off-by: Chas Williams <3chas3 at gmail.com>
---
 drivers/net/bnx2x/bnx2x.c      | 16 +++++++++++-----
 drivers/net/bnx2x/bnx2x_rxtx.c |  2 +-
 2 files changed, 12 insertions(+), 6 deletions(-)

diff --git a/drivers/net/bnx2x/bnx2x.c b/drivers/net/bnx2x/bnx2x.c
index 294711f..d6e28a5 100644
--- a/drivers/net/bnx2x/bnx2x.c
+++ b/drivers/net/bnx2x/bnx2x.c
@@ -5005,11 +5005,17 @@ static void bnx2x_init_rx_rings(struct bnx2x_softc *sc)
 			return;
 		}
 
-/*
- * Activate the BD ring...
- * Warning, this will generate an interrupt (to the TSTORM)
- * so this can only be done after the chip is initialized
- */
+		rxq->rx_bd_head = 0;
+		rxq->rx_bd_tail = rxq->nb_rx_desc;
+		rxq->rx_cq_head = 0;
+		rxq->rx_cq_tail = TOTAL_RCQ_ENTRIES(rxq);
+		*fp->rx_cq_cons_sb = 0;
+
+		/*
+		 * Activate the BD ring...
+		 * Warning, this will generate an interrupt (to the TSTORM)
+		 * so this can only be done after the chip is initialized
+		 */
 		bnx2x_update_rx_prod(sc, fp, rxq->rx_bd_tail, rxq->rx_cq_tail);
 
 		if (i != 0) {
diff --git a/drivers/net/bnx2x/bnx2x_rxtx.c b/drivers/net/bnx2x/bnx2x_rxtx.c
index 9379127..89d93a1 100644
--- a/drivers/net/bnx2x/bnx2x_rxtx.c
+++ b/drivers/net/bnx2x/bnx2x_rxtx.c
@@ -156,7 +156,7 @@ bnx2x_dev_rx_queue_setup(struct rte_eth_dev *dev,
 	rxq->pkt_first_seg = NULL;
 	rxq->pkt_last_seg = NULL;
 	rxq->rx_bd_head = 0;
-	rxq->rx_bd_tail = idx;
+	rxq->rx_bd_tail = rxq->nb_rx_desc;
 
 	/* Allocate CQ chain. */
 	dma_size = BNX2X_RX_CHAIN_PAGE_SZ * rxq->nb_cq_pages;
-- 
2.1.0