[dpdk-dev] [RFC 09/16] testpmd: move csum_show in a function
Olivier MATZ
olivier.matz at 6wind.com
Fri Jan 23 18:53:34 CET 2015
Hi Jijiang,
On 01/23/2015 12:03 PM, Liu, Jijiang wrote:
> + /* display warnings if configuration is not supported by the NIC */
> + rte_eth_dev_info_get(port_id, &dev_info);
> + if ((ol_flags & TESTPMD_TX_OFFLOAD_IP_CKSUM) &&
> + (dev_info.tx_offload_capa & DEV_TX_OFFLOAD_IPV4_CKSUM) == 0) {
> + printf("Warning: hardware IP checksum enabled but not "
> + "supported by port %d\n", port_id);
> + }
> + if ((ol_flags & TESTPMD_TX_OFFLOAD_UDP_CKSUM) &&
> + (dev_info.tx_offload_capa & DEV_TX_OFFLOAD_UDP_CKSUM) == 0) {
> + printf("Warning: hardware UDP checksum enabled but not "
> + "supported by port %d\n", port_id);
> + }
> + if ((ol_flags & TESTPMD_TX_OFFLOAD_TCP_CKSUM) &&
> + (dev_info.tx_offload_capa & DEV_TX_OFFLOAD_TCP_CKSUM) == 0) {
> + printf("Warning: hardware TCP checksum enabled but not "
> + "supported by port %d\n", port_id);
> + }
> + if ((ol_flags & TESTPMD_TX_OFFLOAD_SCTP_CKSUM) &&
> + (dev_info.tx_offload_capa & DEV_TX_OFFLOAD_SCTP_CKSUM) == 0) {
> + printf("Warning: hardware SCTP checksum enabled but not "
> + "supported by port %d\n", port_id);
> + }
>
> The ESTPMD_TX_OFFLOAD_OUTER_IP_CKSUM check is missed here.
Yes, it should be added in this patch:
ethdev: add outer IP offload capability flag
I'll do it for the next version.
Regards,
Olivier
More information about the dev
mailing list