[dpdk-dev] Failed to initialize HW 0x10bc

[Posadas, Emerson]

Nevermind on this issue.

Apparently this was related with a physical issue on the PCIe port. The testpmd and pktgen tool are now working fine.

EP


From: Posadas, Emerson
Sent: Friday, July 3, 2015 11:45 AM
To: 'dev at dpdk.org'
Cc: Richardson, Bruce
Subject: Re: [dpdk-dev] Failed to initialize HW 0x10bc

This is what I'm getting from the DEBUG_INIT and DEBUG_DRIVER flags turned on while running testpmd:

PMD: e1000_setup_link_82571(): e1000_setup_link_82571
PMD: e1000_setup_link_generic(): e1000_setup_link_generic
PMD: e1000_check_reset_block_generic(): e1000_check_reset_block
PMD: e1000_setup_link_generic(): After fix-ups FlowControl is now = 3
PMD: e1000_setup_copper_link_82571(): e1000_setup_copper_link_82571
PMD: e1000_copper_link_setup_igp(): e1000_copper_link_setup_igp
PMD: e1000_phy_hw_reset_generic(): e1000_phy_hw_reset_generic
PMD: e1000_check_reset_block_generic(): e1000_check_reset_block
PMD: e1000_get_hw_semaphore_82571(): e1000_get_hw_semaphore_82571
PMD: e1000_put_hw_semaphore_82571(): e1000_put_hw_semaphore_generic
PMD: e1000_get_cfg_done_82571(): e1000_get_cfg_done_82571
PMD: e1000_get_cfg_done_82571(): MNG configuration cycle has not completed.
PMD: e1000_copper_link_setup_igp(): Error resetting the PHY.
PMD: e1000_clear_hw_cntrs_82571(): e1000_clear_hw_cntrs_82571
PMD: e1000_clear_hw_cntrs_base_generic(): e1000_clear_hw_cntrs_base_generic
PMD: em_hw_init(): Hardware initialization failed
PMD: eth_em_dev_init(): port_id 0 vendorID=0x8086 deviceID=0x10bc: failed to init HW
EAL: Error - exiting with code: 1
  Cause: Requested device 0000:03:00.0 cannot be used

EP