[dpdk-dev] [PATCH] bond: fix check initial link status of slave
Doherty, Declan
declan.doherty at intel.com
Fri Jun 26 09:33:03 CEST 2015
> -----Original Message-----
> From: dev [mailto:dev-bounces at dpdk.org] On Behalf Of Tomasz Kulasek
> Sent: Wednesday, June 24, 2015 1:51 AM
> To: dev at dpdk.org
> Subject: [dpdk-dev] [PATCH] bond: fix check initial link status of slave
>
> On Fortville NIC, link status change interrupt callback is not executed when
> slave in bonding is (re-)started. It causes that slave's NIC is inactive even
> if its link status is up on the start.
>
> This patch invokes lsc callback, just after port's start, to check its initial
> link status and manage properly.
>
> Signed-off-by: Tomasz Kulasek <tomaszx.kulasek at intel.com>
> ---
> drivers/net/bonding/rte_eth_bond_pmd.c | 5 +++++
> 1 file changed, 5 insertions(+)
>
> diff --git a/drivers/net/bonding/rte_eth_bond_pmd.c
> b/drivers/net/bonding/rte_eth_bond_pmd.c
> index 8bad2e1..277b310 100644
> --- a/drivers/net/bonding/rte_eth_bond_pmd.c
> +++ b/drivers/net/bonding/rte_eth_bond_pmd.c
> @@ -1357,6 +1357,11 @@ slave_configure(struct rte_eth_dev
> *bonded_eth_dev,
> return -1;
> }
>
> + /* If lsc interrupt is set, check initial slave's link status */
> + if (slave_eth_dev->driver->pci_drv.drv_flags & RTE_PCI_DRV_INTR_LSC)
> + bond_ethdev_lsc_event_callback(slave_eth_dev->data->port_id,
> + RTE_ETH_EVENT_INTR_LSC, &bonded_eth_dev-
> >data->port_id);
> +
> return 0;
> }
>
> --
> 1.7.9.5
Acked-by : Declan Doherty <declan.doherty at intel.com>
More information about the dev
mailing list