[dpdk-dev] [PATCH] doc/guides: add info on how to enable QAT
Wiles, Keith
keith.wiles at intel.com
Tue Aug 30 15:57:15 CEST 2016
Regards,
Keith
> On Aug 30, 2016, at 8:46 AM, Thomas Monjalon <thomas.monjalon at 6wind.com> wrote:
>
> 2016-08-30 14:26, Eoin Breen:
>> --- a/doc/guides/cryptodevs/qat.rst
>> +++ b/doc/guides/cryptodevs/qat.rst
>> @@ -78,6 +78,11 @@ Installation
>> To use the DPDK QAT PMD an SRIOV-enabled QAT kernel driver is required. The
>> VF devices exposed by this driver will be used by QAT PMD.
>>
>> +To enable QAT in DPDK you must change the ./config/common_base file. Change the
>> +line 'CONFIG_RTE_LIBRTE_PMD_QAT=n' to 'CONFIG_RTE_LIBRTE_PMD_QAT=y' to do this.
>
> No, the recommended way is to change the value in the generated config
> file (.config).
The way I have been changing the default configuration options is to copy the config/defconfig_XYZ file like defconfig_x86_64-native-linuxapp-gcc to a new name say defconfig-x86_64-qat-linuxapp-gcc. Then edit that file and add the CONFIG_RTE_LIBRTE_PMD_QAT=y to the bottom of the file. Then ‘make install T=x86_64-qat-linuxapp-gcc -j’.
Is this not a better way to build a new configuration for a specific reason?
>
> PS: please avoid confidential disclaimer
More information about the dev
mailing list