[dpdk-dev] [PATCH v4] nfp: report link speed using hardware info

Ferruh Yigit ferruh.yigit at intel.com
Mon Dec 19 11:24:14 CET 2016


On 12/16/2016 5:10 PM, Alejandro Lucero wrote:
> Previous reported speed was hardcoded because there was not firmware
> support for getting this information. This change needs to support old
> firmware versions, keeping with the hardcoded report, and the new
> versions, where the firmware makes that information available.
> 
> v4: Make conditional simple and more ellaborated commit comment.
> v3: remove unsed macro
> v2: use RTE_DIM instead of own macro
> 
> Signed-off-by: Alejandro Lucero <alejandro.lucero at netronome.com>
> ---
>  drivers/net/nfp/nfp_net.c      | 27 +++++++++++++++++++++++++--
>  drivers/net/nfp/nfp_net_ctrl.h | 11 +++++++++++
>  2 files changed, 36 insertions(+), 2 deletions(-)
> 
> diff --git a/drivers/net/nfp/nfp_net.c b/drivers/net/nfp/nfp_net.c
<...>
> @@ -831,8 +842,20 @@ static void nfp_net_read_mac(struct nfp_net_hw *hw)
>  		link.link_status = ETH_LINK_UP;
>  
>  	link.link_duplex = ETH_LINK_FULL_DUPLEX;
> -	/* Other cards can limit the tx and rx rate per VF */
> -	link.link_speed = ETH_SPEED_NUM_40G;
> +
> +	nn_link_status = (nn_link_status >> NFP_NET_CFG_STS_LINK_RATE_SHIFT) &
> +			 NFP_NET_CFG_STS_LINK_RATE_MASK;
> +
> +	if ((NFD_CFG_MAJOR_VERSION_of(hw->ver) < 4) ||
> +	    ((NFD_CFG_MINOR_VERSION_of(hw->ver) == 4) &&
> +	    (NFD_CFG_MINOR_VERSION_of(hw->ver) == 0)))
> +		link.link_speed = ETH_SPEED_NUM_40G;
> +	else {
> +		if (nn_link_status >= RTE_DIM(ls_to_ethtool)

This is not compiling fine, missing parenthesis.

> +			link.link_speed = ETH_SPEED_NUM_NONE;
> +		else
> +			link.link_speed = ls_to_ethtool[nn_link_status];
> +	}
>  
>  	if (old.link_status != link.link_status) {
>  		nfp_net_dev_atomic_write_link_status(dev, &link);
<...>



More information about the dev mailing list