[dpdk-dev] [PATCH v2 00/30] update ixgbe shared code to version 16.11.21

Ferruh Yigit ferruh.yigit at intel.com
Wed Dec 21 18:20:20 CET 2016


On 12/21/2016 9:47 AM, Wei Dai wrote:
> update ixgbe shared code to version 16.11.21 .
> v2 changes: 
>   modify subject line and message body of git log according to
>   feedbacks from communtiy.
>   
>   split the 24th patch into 2 separate ones.
>   the 24th of v1 is net/ixgbe/base: add EEE support for DNL-controlled PHYs
>   the 24th of v2 is net/ixgbe/base: add EEE support for some PHYs
>   the 25th of v2 is net/ixgbe/base: remove unused enum type
>   
>   correct RAEDME
> 
> Wei Dai (30):
>   net/ixgbe/base: fix PHY reset check for x550em-ext
>   net/ixgbe/base: fix clearing SAN MAC address
>   net/ixgbe/base: use fast MDIO for non-10G devices
>   net/ixgbe/base: fix PHY identification for x550a
>   net/ixgbe/base: clean up X557 link status check
>   net/ixgbe/base: add driver version to firmware
>   net/ixgbe/base: store link active LED
>   net/ixgbe/base: cleanup X540 checksum calculation
>   net/ixgbe/base: enable LASI only for X552 devices
>   net/ixgbe/base: limit iXFI setup to X552 devices
>   net/ixgbe/base: fix getting PHY type for some x550 devices
>   net/ixgbe/base: fix SGMII link setup for M88 PHYs
>   net/ixgbe/base: cleanup dead EEE code
>   net/ixgbe/base: fix setting unsupported autoneg speeds
>   net/ixgbe/base: support FW commands to control some PHYs
>   net/ixgbe/base: use FW commands to control some PHYs
>   net/ixgbe/base: support busy SGMII register reads
>   net/ixgbe/base: include new speeds in VFLINK interpretation
>   net/ixgbe/base: limit 5Gb support to X550 devices
>   net/ixgbe/base: add physical layer options for FW PHY type
>   net/ixgbe/base: remove unneeded MAC type check
>   net/ixgbe/base: remove unused PHY ID
>   net/ixgbe/base: update FW PHY flow control
>   net/ixgbe/base: add EEE support for some PHYs
>   net/ixgbe/base: remove unused enum type
>   net/ixgbe/base: fix IXGBE LSWFW register
>   net/ixgbe/base: remove unused EEE code
>   net/ixgbe/base: add write flush required by Inphi PHY
>   net/ixgbe/base: report physical layer for SGMII PHY type
>   net/ixgbe/base: update shared code version to 2016.11.21
<...>

Series applied to dpdk-next-net/master, thanks.




More information about the dev mailing list