[dpdk-dev] [PATCH] ethdev: fix documentation for queue start/stop functions

Mcnamara, John john.mcnamara at intel.com
Tue Jul 26 15:49:12 CEST 2016


> -----Original Message-----
> From: dev [mailto:dev-bounces at dpdk.org] On Behalf Of Nikhil P Rao
> Sent: Tuesday, July 26, 2016 1:37 PM
> To: dev at dpdk.org
> Cc: thomas.monjalon at 6wind.com; Rao, Nikhil <nikhil.rao at intel.com>
> Subject: [dpdk-dev] [PATCH] ethdev: fix documentation for queue start/stop
> functions
> 
> From: nikhil.rao at intel.com
> 
> Fix documentation for rte_eth_dev_tx/rx_queue_start/stop() functions

Hi,

Thanks for this. Some comments below.


> 
> Signed-off-by: Nikhil Rao <nikhil.rao at intel.com>
> ---
>  lib/librte_ether/rte_ethdev.h | 12 +++++-------
>  1 file changed, 5 insertions(+), 7 deletions(-)
> 
> diff --git a/lib/librte_ether/rte_ethdev.h b/lib/librte_ether/rte_ethdev.h
> index 022733e..d72fab9 100644
> --- a/lib/librte_ether/rte_ethdev.h
> +++ b/lib/librte_ether/rte_ethdev.h
> @@ -2039,9 +2039,7 @@ int rte_eth_dev_socket_id(uint8_t port_id);  int
> rte_eth_dev_is_valid_port(uint8_t port_id);
> 
>  /*
> - * Allocate mbuf from mempool, setup the DMA physical address
> - * and then start RX for specified queue of a port. It is used
> - * when rx_deferred_start flag of the specified queue is true.
> + * Start specified RX queue of a port.

This change, more or less, reverts the change to this description added in 
commit 3111eae26e2296ec049e6dfc3c0c522d7b9e1c62.

I don't know if "Allocate mbuf from mempool, setup the DMA physical address"
is correct for all pmds so maybe that could be omitted. However, it is 
probably worth keeping the part about the rx_deferred_start flag.



>   *
>   * @param port_id
>   *   The port identifier of the Ethernet device
> @@ -2050,7 +2048,7 @@ int rte_eth_dev_is_valid_port(uint8_t port_id);
>   *   The value must be in the range [0, nb_rx_queue - 1] previously
> supplied
>   *   to rte_eth_dev_configure().
>   * @return
> - *   - 0: Success, the transmit queue is correctly set up.
> + *   - 0: Success, the receive queue is enabled.

+1 to this and the other changes.

John




More information about the dev mailing list