[dpdk-dev] [PATCH v2 1/5] testpmd: add retry option

De Lara Guarch, Pablo pablo.de.lara.guarch at intel.com
Tue Jun 7 11:28:04 CEST 2016



> -----Original Message-----
> From: Wang, Zhihong
> Sent: Wednesday, June 01, 2016 4:28 AM
> To: dev at dpdk.org
> Cc: Ananyev, Konstantin; Richardson, Bruce; De Lara Guarch, Pablo;
> thomas.monjalon at 6wind.com; Wang, Zhihong
> Subject: [PATCH v2 1/5] testpmd: add retry option
> 
> This patch adds retry option in testpmd to prevent most packet losses.
> It can be enabled by "set fwd <mode> retry". All modes except rxonly
> support this option.
> 
> Adding retry mechanism expands test case coverage to support scenarios
> where packet loss affects test results.
> 
> 
> Signed-off-by: Zhihong Wang <zhihong.wang at intel.com>

...

> --- a/doc/guides/testpmd_app_ug/testpmd_funcs.rst
> +++ b/doc/guides/testpmd_app_ug/testpmd_funcs.rst
> @@ -249,8 +249,10 @@ set fwd
> 
>  Set the packet forwarding mode::
> 
> -   testpmd> set fwd (io|mac|mac_retry|macswap|flowgen| \
> -                     rxonly|txonly|csum|icmpecho)
> +   testpmd> set fwd (io|mac|macswap|flowgen| \
> +                     rxonly|txonly|csum|icmpecho) (""|retry)
> +
> +``retry`` can be specified for forwarding engines except ``rx_only``.
> 
>  The available information categories are:
> 
> @@ -260,8 +262,6 @@ The available information categories are:
> 
>  * ``mac``: Changes the source and the destination Ethernet addresses of
> packets before forwarding them.
> 
> -* ``mac_retry``: Same as "mac" forwarding mode, but includes retries if the
> destination queue is full.
> -
>  * ``macswap``: MAC swap forwarding mode.
>    Swaps the source and the destination Ethernet addresses of packets before
> forwarding them.
> 
> @@ -392,7 +392,7 @@ Set number of packets per burst::
> 
>  This is equivalent to the ``--burst command-line`` option.
> 
> -In ``mac_retry`` forwarding mode, the transmit delay time and number of
> retries can also be set::
> +When retry is enabled, the transmit delay time and number of retries can
> also be set::
> 
>     testpmd> set burst tx delay (micrseconds) retry (num)

Could you fix the typo "micrseconds" in this patch?
 
> 
> --
> 2.5.0

Apart from this,

Acked-by: Pablo de Lara <pablo.de.lara.guarch at intel.com>



More information about the dev mailing list