[dpdk-dev] [PATCH / RFC ] ethdev: Allow rte_eth_dev_configure with zero RX/TX queues

[Simon Kågström]

Ping? Any more comments on this?

// Simon

On 2016-05-16 15:16, Simon Kågström wrote:
> On 2016-05-16 14:43, Pattan, Reshma wrote:
>>>> This was added to allow devices,  at least with one direction (RX/TX)
>>> supported. As, devices with both directions disabled doesn't make  sense right?
>>>
>>> Well, not for running them, no. But this is a part of the shutdown procedure
>>> between tests (I should have been more clear I guess).
>>
>> Yes I understood this. But I am not sure if you can use rte_eth_dev_configure(port, 0, 0) to free the resources.
>> Can you check if you can use rte_eth_dev_rx_queue_stop/ rte_eth_dev_tx_queue_stop to achieve the same, because they do take care of
>> releasing mbufs, but doesn't free the queue's sw-ring and queue.
> 
> But isn't that very strange behavior. Aren't the descriptor rings
> allocated in rx_queue_setup()? If so, the sequence
> 
>   rx_queue_stop(); // Release buffers
>   rx_queue_start();
> 
> would leave the descriptor ring empty after start, i.e., not able to
> receive data.
> 
> // Simon
>