[dpdk-dev] [PATCH] mbuf: new flag when Vlan is stripped

Olivier Matz olivier.matz at 6wind.com
Mon May 23 11:12:49 CEST 2016


Hi Konstantin,

On 05/23/2016 10:59 AM, Ananyev, Konstantin wrote:
> Hi Olivier,
> 
>> -----Original Message-----
>> From: Olivier Matz [mailto:olivier.matz at 6wind.com]
>> Sent: Monday, May 23, 2016 9:47 AM
>> To: dev at dpdk.org
>> Cc: johndale at cisco.com; Ananyev, Konstantin; Zhang, Helin; adrien.mazarguil at 6wind.com; rahul.lakkireddy at chelsio.com;
>> alejandro.lucero at netronome.com; sony.chacko at qlogic.com
>> Subject: [PATCH] mbuf: new flag when Vlan is stripped
>>
>> The behavior of PKT_RX_VLAN_PKT was not very well defined, resulting in
>> PMDs not advertising the same flags in similar conditions.
>>
>> Following discussion in [1], introduce 2 new flags PKT_RX_VLAN_STRIPPED
>> and PKT_RX_QINQ_STRIPPED that are better defined:
>>
>>   PKT_RX_VLAN_STRIPPED: a vlan has been stripped by the hardware and its
>>   tci is saved in mbuf->vlan_tci. This can only happen if vlan stripping
>>   is enabled in the RX configuration of the PMD.
>>
>> For now, the old flag PKT_RX_VLAN_PKT is kept but marked as deprecated.
>> It should be removed from applications and PMDs in a future revision.
>>
>> This patch also updates the drivers. For PKT_RX_VLAN_PKT:
>>
>> - e1000, enic, i40e, mlx5, nfp, vmxnet3: done, PKT_RX_VLAN_PKT already
>>   had the same meaning than PKT_RX_VLAN_STRIPPED, minor update is
>>   required.
>> - fm10k: done, PKT_RX_VLAN_PKT already had the same meaning than
>>   PKT_RX_VLAN_STRIPPED, and vlan stripping is always enabled on fm10k.
>> - ixgbe: modification done for standard mode (vector does not support
>>   vlan stripping)
>> - the other drivers do not support vlan stripping.
>>
>> For PKT_RX_QINQ_PKT, it was only supported on i40e, and the meaning was
>> already correct, so we can reuse the same value for PKT_RX_QINQ_STRIPPED.
>>
> 
> I don't see ixgbe/i4oe_rxtx_vec.c updated.
> Would it be another patch for them?

The ixgbe vector and i40e vector do not support vlan stripping, so
from what I see there is nothing to do:
- The new flag PKT_RX_VLAN_STRIPPED is never returned
- We keep the old behavior for PKT_RX_VLAN_PKT.

Thanks,
Olivier


More information about the dev mailing list