[dpdk-dev] [PATCH 1/1] doc: clarify usage of testpmd mac fwd mode
Mark Kavanagh
mark.b.kavanagh at intel.com
Fri Sep 9 18:15:52 CEST 2016
Explain default testpmd behavior in mac fwd mode to remove
amiguity/confusion regarding user's ability to specify Ethernet
addresses.
Signed-off-by: Mark Kavanagh <mark.b.kavanagh at intel.com>
---
doc/guides/testpmd_app_ug/testpmd_funcs.rst | 3 +++
1 file changed, 3 insertions(+)
diff --git a/doc/guides/testpmd_app_ug/testpmd_funcs.rst b/doc/guides/testpmd_app_ug/testpmd_funcs.rst
index f87e0c2..6ab910e 100644
--- a/doc/guides/testpmd_app_ug/testpmd_funcs.rst
+++ b/doc/guides/testpmd_app_ug/testpmd_funcs.rst
@@ -267,6 +267,9 @@ The available information categories are:
This is the default mode.
* ``mac``: Changes the source and the destination Ethernet addresses of packets before forwarding them.
+ Default application behaviour is to set source Ethernet address to that of the transmitting interface, and destination
+ address to a dummy value (set during init). The user may specify a target destination Ethernet address via the 'eth-peer' or
+ 'eth-peer-configfile' command-line options. It is not currently possible to specify a specific source Ethernet address.
* ``macswap``: MAC swap forwarding mode.
Swaps the source and the destination Ethernet addresses of packets before forwarding them.
--
1.9.3
More information about the dev
mailing list