[dpdk-dev] [PATCH 1/6] net/tap: use correct tap name

[Wiles, Keith]

> On Feb 1, 2017, at 2:11 AM, Pascal Mazon <pascal.mazon at 6wind.com> wrote:
> 
> On 02/01/2017 12:29 AM, Wiles, Keith wrote:
>> 
>>> On Jan 31, 2017, at 10:39 AM, Pascal Mazon <pascal.mazon at 6wind.com> wrote:
>>> 
>>> On 01/31/2017 05:06 PM, Wiles, Keith wrote:>
>>>> Looking at the changes to set the link up/down and the adding the two functions. I noticed in the stop/start routines I was set the link in DPDK and not adjusting the interface link. Should the stop/start routine also do the same thing?
>>>> 
>>> 
>>> Well, my patch is probably wrong.
>>> The best option would probably be to set dev->data->dev_link.link_status
>>> appropriately inside tap_link_set() only.
>>> 
>>> I'm not sure it's compulsory to actually set the link UP in tap_dev_start()
>>> (respectively DOWN in tap_dev_stop()).
>>> If it is, however, it would be best done using tap_link_set() in those
>>> functions.
>> 
>> I was setting the link up/down in both places in the old code. The gotta is link up/down came later (I guess) and applications only call start/stop. In the other drivers like ring the like they tend to set link in start/stop and in link up/down, which is what I patterned my driver on.
>> 
>> I looked around and the only applications calling link up/down was testpmd and ip_pipeline, but all of the apps call start/stop. Even the docs to not suggest that link up/down be used it appears start/stop must set the Link state and the developer can call link up/down APIs if needed for others reasons.
>> 
>> I assume the link up/down only effects the link state and the start/stop is creating/destroying resources.
>> 
>> My only solution I guess is to add the link up/down code to the start/stop API.
> 
> I'm not sure I understand your conclusion.
> If the apps usually call start/stop only, then definitely those functions should set the link state appropriately.
> To that effect, I think it best to just call tap_link_set() in tap_dev_start() (and similar for stopping).
> Apps with just start/stop functions would get the expected behavior, and the tap PMD would also support setting the link up/down independently, for testpmd and ip_pipeline for example.
> 
> Does that sound fine?

Yes, this was what I was trying to say and calling tap_link_set() in tap_dev_start() is the solution.

> 
> 
>> 
>>> 
>>> --
>>> Pascal Mazon
>>> www.6wind.com
>> 
>> Regards,
>> Keith
>> 
> 
> 
> -- 
> Pascal Mazon
> www.6wind.com

Regards,
Keith