[dpdk-dev] [PATCH v10 03/11] net/failsafe: add fail-safe PMD
Gaëtan Rivet
gaetan.rivet at 6wind.com
Tue Jul 18 01:17:07 CEST 2017
On Mon, Jul 17, 2017 at 02:56:54PM +0100, Ferruh Yigit wrote:
<...>
> > +Stats per queue = Y
> > +Unicast MAC filter = Y
> > +Queue start/stop = Y
> > +Jumbo frame = Y
> > +Multicast MAC filter = Y
>
> Is above ones supported by PMD, I don't see them unless I miss something.
>
Queue start/stop was an error.
All others are supported as long as the slave support it.
<...>
> > + sdev = TX_SUBDEV(dev);
> > + rte_eth_dev_info_get(PORT_ID(sdev), &PRIV(dev)->infos);
> > + PRIV(dev)->infos.rx_offload_capa = rx_offload_capa;
>
> Is intention &= ?
>
rx_offload_capa is already set a little higher, and then an AND is done
on it with all slaves. The "=" is correct here. Thanks for asking
though, it's always useful to check :).
---
I fixed all other remarks. I will wait a little for any possible
additional changes you might want to point before sending the new
version.
--
Gaëtan Rivet
6WIND
More information about the dev
mailing list