[dpdk-dev] [PATCH v2 2/2] testpmd: update testpmd documentation to include noisy forwarding mode
Jens Freimann
jfreimann at redhat.com
Mon Apr 16 22:17:15 CEST 2018
On Fri, Apr 13, 2018 at 02:19:28PM +0100, Ferruh Yigit wrote:
>On 4/13/2018 12:37 PM, Jens Freimann wrote:
>> Signed-off-by: Jens Freimann <jfreimann at redhat.com>
>> ---
>> doc/guides/testpmd_app_ug/run_app.rst | 27 +++++++++++++++++++++++++++
>> doc/guides/testpmd_app_ug/testpmd_funcs.rst | 7 +++++--
>> 2 files changed, 32 insertions(+), 2 deletions(-)
>>
>> diff --git a/doc/guides/testpmd_app_ug/run_app.rst b/doc/guides/testpmd_app_ug/run_app.rst
>> index 1fd53958a..0b7046bb0 100644
>> --- a/doc/guides/testpmd_app_ug/run_app.rst
>> +++ b/doc/guides/testpmd_app_ug/run_app.rst
>> @@ -340,6 +340,7 @@ The commandline options are:
>> icmpecho
>> ieee1588
>> tm
>> + noisy
>>
>> * ``--rss-ip``
>>
>> @@ -479,3 +480,29 @@ The commandline options are:
>>
>> Set the hexadecimal bitmask of TX queue offloads.
>> The default value is 0.
>> +
>> +* ``--buffersize-before-sending=N``
>> +
>> + Set the number of maximum elements of the FIFO queue to be created
>> + for buffering packets. Only available with the noisy forwarding mode.
>> + The default value is 0.
>> +
>> +* ``--flush-timeout=N``
>> +
>> + Set the size of the FIFO queue to be created for buffering packets.
>> + Only available with the noisy forwarding mode. The default value is 0.
>
>Some of the there parameter names are so generic when you think them in the
>scope of the whole testpmd it can be confusing and hard to understand what they
>are for.
>
>What do you think adding a prefix to all noisy neighbor related commands?
Yes, I think it is a good point. Thanks for the review!
regards,
Jens
>
>> +
>> +* ``--nb-rnd-read=N``
>> +
>> + Set the number of reads to be done in noisy neighbour simulation memory buffer.
>> + Only available with the noisy forwarding mode. The default value is 0.
>> +
>> +* ``--nb-rnd-write=N``
>> +
>> + Set the number of writes to be done in noisy neighbour simulation memory buffer.
>> + Only available with the noisy forwarding mode. The default value is 0.
>> +
>> +* ``--nb-rnd-write=N``
>> +
>> + Set the number of r/w access to be done in noisy neighbour simulation memory buffer.
>> + Only available with the noisy forwarding mode. The default value is 0.
>
><...>
More information about the dev
mailing list