[dpdk-dev] [PATCH v1] doc: update mlx4 flow limitations
Marcelo Ricardo Leitner
marcelo.leitner at gmail.com
Sun Feb 11 20:30:30 CET 2018
On Thu, Feb 08, 2018 at 06:55:54AM +0000, Ophir Munk wrote:
> From: Moti Haimovsky <motih at mellanox.com>
>
> This patch updates mlx4 documentation with flow
> configuration limitations imposed by NIC hardware and
> PMD implementation
>
> Signed-off-by: Ophir Munk <ophirmu at mellanox.com>
> ---
> doc/guides/nics/mlx4.rst | 77 ++++++++++++++++++++++++++++++++++++++++++++++++
> 1 file changed, 77 insertions(+)
>
> diff --git a/doc/guides/nics/mlx4.rst b/doc/guides/nics/mlx4.rst
> index 98b9716..b81a875 100644
> --- a/doc/guides/nics/mlx4.rst
> +++ b/doc/guides/nics/mlx4.rst
> @@ -515,3 +515,80 @@ devices managed by librte_pmd_mlx4.
> Port 3 Link Up - speed 40000 Mbps - full-duplex
> Done
> testpmd>
> +
> +Limitations
> +-----------
> +
> +Flow rules
> +~~~~~~~~~~
> +
> +L2 (eth)
> +^^^^^^^^
> +
> +- Can only use real destination MAC
> +- Source MAC is not taken into consideration
> +
> + For example using testpmd command - src mask must be 00:00:00:00:00:00
> + otherwise the following command will fail
> +
> +.. code-block:: console
> +
> + testpmd> flow create 1 ingress pattern eth
> + src spec 00:16:3e:2b:e6:47 src mask FF:FF:FF:FF:FF:FF
> + / end actions drop / end
> +
> +- Supports only full MASK
> +
> + For example the following testpmd command will fail
> +
> +.. code-block:: console
> +
> + testpmd> flow create 1 ingress pattern eth
> + src spec 00:16:3e:2b:e6:47
> + dst spec 4A:11:6C:FA:60:D0 dst mask FF:00:FF:FF:FF:00
> + / end actions drop / end
> +
> +
> +- When configured to run in promiscuous or all-multicast modes does
> + not support additional rules
> +- Does not support the explicit exclusion of all multicast traffic
> +- Does not support partial VLAN TCI VID matching
> +
> +L3 (ipv4)
> +^^^^^^^^^
> +
> +- Supports only 0 or full mask. Prerequisites: Need to have eth dst spec
Plans on updating mlx5 guide with this info too?
AFAIK ConnectX-4 and 5 also have this limitation and it can save some
hours of debugging.
Marcelo
More information about the dev
mailing list