[dpdk-dev] [PATCH 2/7] net/mlx5: remove redundant objects in probe code
Adrien Mazarguil
adrien.mazarguil at 6wind.com
Fri May 25 18:35:17 CEST 2018
This patch gets rid of redundant calls to open the device and query its
attributes in order to simplify the code.
Signed-off-by: Adrien Mazarguil <adrien.mazarguil at 6wind.com>
---
drivers/net/mlx5/mlx5.c | 60 +++++++++++++++++++++-----------------------
1 file changed, 28 insertions(+), 32 deletions(-)
diff --git a/drivers/net/mlx5/mlx5.c b/drivers/net/mlx5/mlx5.c
index 602f952ca..41a542ebc 100644
--- a/drivers/net/mlx5/mlx5.c
+++ b/drivers/net/mlx5/mlx5.c
@@ -652,10 +652,10 @@ mlx5_pci_probe(struct rte_pci_driver *pci_drv __rte_unused,
{
struct ibv_device **list = NULL;
struct ibv_device *ibv_dev;
+ struct ibv_context *ctx = NULL;
+ struct ibv_device_attr_ex attr;
struct mlx5dv_context dv_attr = { .comp_mask = 0 };
int err = 0;
- struct ibv_context *attr_ctx = NULL;
- struct ibv_device_attr_ex device_attr;
unsigned int vf = 0;
unsigned int mps;
unsigned int cqe_comp;
@@ -712,12 +712,12 @@ mlx5_pci_probe(struct rte_pci_driver *pci_drv __rte_unused,
PCI_DEVICE_ID_MELLANOX_CONNECTX5VF) ||
(pci_dev->id.device_id ==
PCI_DEVICE_ID_MELLANOX_CONNECTX5EXVF));
- attr_ctx = mlx5_glue->open_device(list[i]);
+ ctx = mlx5_glue->open_device(list[i]);
rte_errno = errno;
err = rte_errno;
break;
}
- if (attr_ctx == NULL) {
+ if (ctx == NULL) {
switch (err) {
case 0:
DRV_LOG(ERR,
@@ -820,23 +820,20 @@ mlx5_pci_probe(struct rte_pci_driver *pci_drv __rte_unused,
DRV_LOG(WARNING, "MPLS over GRE/UDP tunnel offloading disabled due to"
" old OFED/rdma-core version or firmware configuration");
#endif
- err = mlx5_glue->query_device_ex(attr_ctx, NULL, &device_attr);
+ err = mlx5_glue->query_device_ex(ctx, NULL, &attr);
if (err) {
DEBUG("ibv_query_device_ex() failed");
goto error;
}
- DRV_LOG(INFO, "%u port(s) detected",
- device_attr.orig_attr.phys_port_cnt);
- for (i = 0; i < device_attr.orig_attr.phys_port_cnt; i++) {
+ DRV_LOG(INFO, "%u port(s) detected", attr.orig_attr.phys_port_cnt);
+ for (i = 0; i < attr.orig_attr.phys_port_cnt; i++) {
char name[RTE_ETH_NAME_MAX_LEN];
int len;
uint32_t port = i + 1; /* ports are indexed from one */
- struct ibv_context *ctx = NULL;
struct ibv_port_attr port_attr;
struct ibv_pd *pd = NULL;
struct priv *priv = NULL;
struct rte_eth_dev *eth_dev = NULL;
- struct ibv_device_attr_ex device_attr_ex;
struct ether_addr mac;
struct mlx5_dev_config config = {
.cqe_comp = cqe_comp,
@@ -863,7 +860,7 @@ mlx5_pci_probe(struct rte_pci_driver *pci_drv __rte_unused,
len = snprintf(name, sizeof(name), PCI_PRI_FMT,
pci_dev->addr.domain, pci_dev->addr.bus,
pci_dev->addr.devid, pci_dev->addr.function);
- if (device_attr.orig_attr.phys_port_cnt > 1)
+ if (attr.orig_attr.phys_port_cnt > 1)
snprintf(name + len, sizeof(name), " port %u", i);
if (rte_eal_process_type() == RTE_PROC_SECONDARY) {
eth_dev = rte_eth_dev_attach_secondary(name);
@@ -905,7 +902,8 @@ mlx5_pci_probe(struct rte_pci_driver *pci_drv __rte_unused,
continue;
}
DRV_LOG(DEBUG, "using port %u", port);
- ctx = mlx5_glue->open_device(ibv_dev);
+ if (!ctx)
+ ctx = mlx5_glue->open_device(ibv_dev);
if (ctx == NULL) {
err = ENODEV;
goto port_error;
@@ -947,7 +945,7 @@ mlx5_pci_probe(struct rte_pci_driver *pci_drv __rte_unused,
priv->ctx = ctx;
strncpy(priv->ibdev_path, priv->ctx->device->ibdev_path,
sizeof(priv->ibdev_path));
- priv->device_attr = device_attr;
+ priv->device_attr = attr;
priv->port = port;
priv->pd = pd;
priv->mtu = ETHER_MTU;
@@ -958,17 +956,12 @@ mlx5_pci_probe(struct rte_pci_driver *pci_drv __rte_unused,
strerror(rte_errno));
goto port_error;
}
- err = mlx5_glue->query_device_ex(ctx, NULL, &device_attr_ex);
- if (err) {
- DRV_LOG(ERR, "ibv_query_device_ex() failed");
- goto port_error;
- }
- config.hw_csum = !!(device_attr_ex.device_cap_flags_ex &
+ config.hw_csum = !!(attr.device_cap_flags_ex &
IBV_DEVICE_RAW_IP_CSUM);
DRV_LOG(DEBUG, "checksum offloading is %ssupported",
(config.hw_csum ? "" : "not "));
#ifdef HAVE_IBV_DEVICE_COUNTERS_SET_SUPPORT
- config.flow_counter_en = !!(device_attr.max_counter_sets);
+ config.flow_counter_en = !!attr.max_counter_sets;
mlx5_glue->describe_counter_set(ctx, 0, &cs_desc);
DRV_LOG(DEBUG,
"counter type = %d, num of cs = %ld, attributes = %d",
@@ -976,7 +969,7 @@ mlx5_pci_probe(struct rte_pci_driver *pci_drv __rte_unused,
cs_desc.attributes);
#endif
config.ind_table_max_size =
- device_attr_ex.rss_caps.max_rwq_indirection_table_size;
+ attr.rss_caps.max_rwq_indirection_table_size;
/* Remove this check once DPDK supports larger/variable
* indirection tables. */
if (config.ind_table_max_size >
@@ -984,29 +977,28 @@ mlx5_pci_probe(struct rte_pci_driver *pci_drv __rte_unused,
config.ind_table_max_size = ETH_RSS_RETA_SIZE_512;
DRV_LOG(DEBUG, "maximum Rx indirection table size is %u",
config.ind_table_max_size);
- config.hw_vlan_strip = !!(device_attr_ex.raw_packet_caps &
+ config.hw_vlan_strip = !!(attr.raw_packet_caps &
IBV_RAW_PACKET_CAP_CVLAN_STRIPPING);
DRV_LOG(DEBUG, "VLAN stripping is %ssupported",
(config.hw_vlan_strip ? "" : "not "));
- config.hw_fcs_strip = !!(device_attr_ex.raw_packet_caps &
+ config.hw_fcs_strip = !!(attr.raw_packet_caps &
IBV_RAW_PACKET_CAP_SCATTER_FCS);
DRV_LOG(DEBUG, "FCS stripping configuration is %ssupported",
(config.hw_fcs_strip ? "" : "not "));
#ifdef HAVE_IBV_WQ_FLAG_RX_END_PADDING
- config.hw_padding = !!device_attr_ex.rx_pad_end_addr_align;
+ config.hw_padding = !!attr.rx_pad_end_addr_align;
#endif
DRV_LOG(DEBUG,
"hardware Rx end alignment padding is %ssupported",
(config.hw_padding ? "" : "not "));
config.vf = vf;
- config.tso = ((device_attr_ex.tso_caps.max_tso > 0) &&
- (device_attr_ex.tso_caps.supported_qpts &
+ config.tso = (attr.tso_caps.max_tso > 0 &&
+ (attr.tso_caps.supported_qpts &
(1 << IBV_QPT_RAW_PACKET)));
if (config.tso)
- config.tso_max_payload_sz =
- device_attr_ex.tso_caps.max_tso;
+ config.tso_max_payload_sz = attr.tso_caps.max_tso;
if (config.mps && !mps) {
DRV_LOG(ERR,
"multi-packet send not supported on this device"
@@ -1153,14 +1145,18 @@ mlx5_pci_probe(struct rte_pci_driver *pci_drv __rte_unused,
priv, mem_event_cb);
rte_rwlock_write_unlock(&mlx5_shared_data->mem_event_rwlock);
rte_eth_dev_probing_finish(eth_dev);
+ /*
+ * Each eth_dev instance is assigned its own Verbs context,
+ * since this one is consumed, let the next iteration open
+ * another.
+ */
+ ctx = NULL;
continue;
port_error:
if (priv)
rte_free(priv);
if (pd)
claim_zero(mlx5_glue->dealloc_pd(pd));
- if (ctx)
- claim_zero(mlx5_glue->close_device(ctx));
if (eth_dev && rte_eal_process_type() == RTE_PROC_PRIMARY)
rte_eth_dev_release_port(eth_dev);
break;
@@ -1172,8 +1168,8 @@ mlx5_pci_probe(struct rte_pci_driver *pci_drv __rte_unused,
* way to enumerate the registered ethdevs to free the previous ones.
*/
error:
- if (attr_ctx)
- claim_zero(mlx5_glue->close_device(attr_ctx));
+ if (ctx)
+ claim_zero(mlx5_glue->close_device(ctx));
if (list)
mlx5_glue->free_device_list(list);
if (err) {
--
2.11.0
More information about the dev
mailing list