[dpdk-dev] [PATCH v2] ethdev: remove device-specific comments from VLAN API

[David Marchand]

On Tue, Aug 4, 2020 at 11:48 AM Thomas Monjalon <thomas at monjalon.net> wrote:
>
> Some confusing comments were still present from old days,
> when most drivers were from Intel.
>
> Signed-off-by: Thomas Monjalon <thomas at monjalon.net>
> ---
> v2: remove i40e comment for pvid field
> ---
>  lib/librte_ethdev/rte_ethdev.h | 12 ++----------
>  1 file changed, 2 insertions(+), 10 deletions(-)
>
> diff --git a/lib/librte_ethdev/rte_ethdev.h b/lib/librte_ethdev/rte_ethdev.h
> index 57e4a6ca58..d29930fd84 100644
> --- a/lib/librte_ethdev/rte_ethdev.h
> +++ b/lib/librte_ethdev/rte_ethdev.h
> @@ -924,7 +924,6 @@ struct rte_eth_txmode {
>          */
>         uint64_t offloads;
>
> -       /* For i40e specifically */
>         uint16_t pvid;
>         __extension__
>         uint8_t hw_vlan_reject_tagged : 1,
> @@ -2846,7 +2845,6 @@ int rte_eth_dev_vlan_filter(uint16_t port_id, uint16_t vlan_id, int on);
>
>  /**
>   * Enable/Disable hardware VLAN Strip by a rx queue of an Ethernet device.
> - * 82599/X540/X550 can support VLAN stripping at the rx queue level
>   *
>   * @param port_id
>   *   The port identifier of the Ethernet device.
> @@ -2868,8 +2866,7 @@ int rte_eth_dev_set_vlan_strip_on_queue(uint16_t port_id, uint16_t rx_queue_id,
>
>  /**
>   * Set the Outer VLAN Ether Type by an Ethernet device, it can be inserted to
> - * the VLAN Header. This is a register setup available on some Intel NIC, not
> - * but all, please check the data sheet for availability.
> + * the VLAN header.
>   *
>   * @param port_id
>   *   The port identifier of the Ethernet device.
> @@ -2888,12 +2885,7 @@ int rte_eth_dev_set_vlan_ether_type(uint16_t port_id,
>                                     uint16_t tag_type);
>
>  /**
> - * Set VLAN offload configuration on an Ethernet device
> - * Enable/Disable Extended VLAN by an Ethernet device, This is a register setup
> - * available on some Intel NIC, not but all, please check the data sheet for
> - * availability.
> - * Enable/Disable VLAN Strip can be done on rx queue for certain NIC, but here
> - * the configuration is applied on the port level.
> + * Set VLAN offload configuration on an Ethernet device.
>   *
>   * @param port_id
>   *   The port identifier of the Ethernet device.

Reviewed-by: David Marchand <david.marchand at redhat.com>


-- 
David Marchand