[dpdk-dev] [PATCH v1] net/mlx5: fix IPIP multi tunnel validation

[Lior Margalit]

A flow rule must not include multiple tunnel layers.
An attempt to create such a rule, for example:
testpmd> flow create .../ vxlan / eth / ipv4 proto is 4 / end <actions>
results in an unclear error.

In the current implementation there is a check for
multiple IPIP tunnels, but not for combination of IPIP
and a different kind of tunnel, such as VXLAN. The fix
is to enhance the above check to use MLX5_FLOW_LAYER_TUNNEL
that consists of all the tunnel masks. The error message
will be "multiple tunnel not supported".

Fixes: 5e33bebdd8d3 ("net/mlx5: support IP-in-IP tunnel")
Cc: stable at dpdk.org

Signed-off-by: Lior Margalit <lmargalit at nvidia.com>
Acked-by: Ori Kam <orika at nvidia.com>
---
 drivers/net/mlx5/mlx5_flow.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/net/mlx5/mlx5_flow.c b/drivers/net/mlx5/mlx5_flow.c
index e5e062d09a..c5c767aaee 100644
--- a/drivers/net/mlx5/mlx5_flow.c
+++ b/drivers/net/mlx5/mlx5_flow.c
@@ -2124,7 +2124,7 @@ mlx5_flow_validate_item_ipv4(const struct rte_flow_item *item,
 					  RTE_FLOW_ERROR_TYPE_ITEM, item,
 					  "IPv4 cannot follow L2/VLAN layer "
 					  "which ether type is not IPv4");
-	if (item_flags & MLX5_FLOW_LAYER_IPIP) {
+	if (item_flags & MLX5_FLOW_LAYER_TUNNEL) {
 		if (mask && spec)
 			next_proto = mask->hdr.next_proto_id &
 				     spec->hdr.next_proto_id;
@@ -2232,7 +2232,7 @@ mlx5_flow_validate_item_ipv6(const struct rte_flow_item *item,
 					  "which ether type is not IPv6");
 	if (mask && mask->hdr.proto == UINT8_MAX && spec)
 		next_proto = spec->hdr.proto;
-	if (item_flags & MLX5_FLOW_LAYER_IPV6_ENCAP) {
+	if (item_flags & MLX5_FLOW_LAYER_TUNNEL) {
 		if (next_proto == IPPROTO_IPIP || next_proto == IPPROTO_IPV6)
 			return rte_flow_error_set(error, EINVAL,
 						  RTE_FLOW_ERROR_TYPE_ITEM,
-- 
2.21.0