[PATCH] ethdev: add dump regs for telemetry

[fengchengwen]

Hi Ferruh,

On 2024/1/10 2:06, Ferruh Yigit wrote:
> On 1/9/2024 2:19 AM, Jie Hai wrote:
>> On 2023/12/14 20:49, Ferruh Yigit wrote:
>>> On 12/14/2023 1:56 AM, Jie Hai wrote:
>>>> The ethdev library now registers a telemetry command for
>>>> dump regs.
>>>>
>>>> An example usage is shown below:
>>>> --> /ethdev/regs,test
>>>> {
>>>>    "/ethdev/regs": {
>>>>      "regs_offset": 0,
>>>>      "regs_length": 3192,
>>>>      "regs_width": 4,
>>>>      "device_version": "0x1080f00",
>>>>      "regs_file": "port_0_regs_test"
>>>>    }
>>>> }
>>
>>>
>>> Above code writes register data to a file.
>>>
>>> I am not sure about this kind of usage of telemetry command, that it
>>> cause data to be written to a file.
>>>
>>> My understanding is, telemetry usage is based on what telemetry client
>>> receives.
>>> What do you think just keep the 'reg_info' fields excluding data to the
>>> file?
>>>
>>> .Hi, Ferruh
>>
>> I tried to write all register information to telemetry data,
>> but gave up because some drivers had too many registers (eg.ixgbe)
>> to carry. Therefore, the writing data to file approach is selected.
>>
>> When we query a register, the register content is the key.
>> The information such as the width and length is only auxiliary
>> information. If the register data cannot be obtained, the auxiliary
>> information is optional. So I don't think register data should be removed.
>>
>> In my opinion, writing a file is a more appropriate way to do it.
>> I wonder if there's a better way.
>>
>>
> 
> Is there a usecase to get register information from telemetry interface?

Among the available tools:
1, ethtool/proc-info: should use multi-process mechanism to connect to the main process
2, telemetry: easier, lighter load, and it don't need re-probe the ethdev in the secondary process,
              and also cost more resource, like hugepage, cores.

>From our users, they prefer use the second 'telemetry', so I think we should move
more status-query-points to telemetry.

As for this question, I think it's okay to get register info from telemetry.



Another question, we have some internal registers, which:
1. Is not suitable expose by xstats, because they may includes configuration
2. Is not suitable expose by dumps, because this dumps is hard to understand (because it only has value).

So we plan to add some telemetry points in the driver itself, so we could display them like xstats:
"xxxx" : 0x1234
"yyyy" : 0x100

Will the community accept this kind of telemetry points which limit one driver ?

Thanks.

> 
> .
>