[dts] [PATCH V2][dts 2/2] add allmutlicast and broadcast test case

[Liu, Yong]

Thanks, one question below.

> -----Original Message-----
> From: dts [mailto:dts-bounces at dpdk.org] On Behalf Of xu,huilong
> Sent: Thursday, April 21, 2016 11:03 PM
> To: dts at dpdk.org
> Cc: Xu, HuilongX
> Subject: [dts] [PATCH V2][dts 2/2] add allmutlicast and broadcast test
> case
> 
> Signed-off-by: xu,huilong <huilongx.xu at intel.com>
> ---
>  tests/TestSuite_dynamic_config.py | 69 ++++++++++++++++++++++++++++++++--
> -----
>  1 file changed, 58 insertions(+), 11 deletions(-)
> 
> diff --git a/tests/TestSuite_dynamic_config.py
> b/tests/TestSuite_dynamic_config.py
> index ba740b1..380fa6d 100644
> --- a/tests/TestSuite_dynamic_config.py
> +++ b/tests/TestSuite_dynamic_config.py
> @@ -1,6 +1,6 @@
>  # BSD LICENSE
>  #
> -# Copyright(c) 2010-2015 Intel Corporation. All rights reserved.
> +# Copyright(c) 2010-2016 Intel Corporation. All rights reserved.
>  # All rights reserved.
>  #
>  # Redistribution and use in source and binary forms, with or without
> @@ -67,18 +67,12 @@ class TestDynamicConfig(TestCase):
>          print self.dut_ports
> 
>          # Verify that enough ports are available
> -        if self.nic in ["fortville_eagle", "fortville_spirit",
> "fortville_spirit_single"]:
> -            self.verify(len(self.dut_ports) >= 2, "Insufficient ports")
> -        else:
> -            self.verify(len(self.dut_ports) >= 1, "Insufficient ports")
> +        self.verify(len(self.dut_ports) >= 2, "Insufficient ports")
> 
>          # Prepare cores and ports
>          cores = self.dut.get_core_list('1S/2C/2T')
>          coreMask = dts.create_mask(cores)
> -        if self.nic in ["fortville_eagle", "fortville_spirit",
> "fortville_spirit_single"]:
> -            portMask = dts.create_mask(self.dut_ports[:2])
> -        else:
> -            portMask = dts.create_mask([self.dut_ports[0]])
> +        portMask = dts.create_mask(self.dut_ports[:2])

One question here, is this case must need two ports? Reduce port requirement is our long time strategy. 
It will benefit for some NIC which only one port available. 

> 
>          # launch app
>          cmd = "./%s/build/app/test-pmd/testpmd -c %s -n 3 -- -i --rxpt=0
> \
> @@ -99,8 +93,7 @@ class TestDynamicConfig(TestCase):
>          self.verify(cmp(ret.lower(), self.dest) == 0, "MAC address wrong")
>          self.verify("Promiscuous mode: enabled" in out,
>                      "wrong default promiscuous value")
> -        if self.nic in ["fortville_eagle", "fortville_spirit",
> "fortville_spirit_single"]:
> -            self.dut.send_expect("start", "testpmd> ", 120)
> +        self.dut.send_expect("start", "testpmd> ", 120)
> 
>      def dynamic_config_send_packet(self, portid,
> destMac="00:11:22:33:44:55"):
>          """
> @@ -129,6 +122,7 @@ class TestDynamicConfig(TestCase):
>          portid = self.dut_ports[0]
> 
>          # get the current rx statistic
> +        out = self.dut.send_expect("clear port stats all" , "testpmd> ")
>          out = self.dut.send_expect("show port stats %d" % portid,
> "testpmd> ")
>          cur_rxpkt = dts.regexp(out, "RX-packets: ([0-9]+)")
> 
> @@ -211,7 +205,60 @@ class TestDynamicConfig(TestCase):
>              # check the pakcet increasment
>              self.verify(int(cur_rxpkt) == int(
>                  pre_rxpkt) + 1, "2nd packet increasment error")
> +    def test_dynamic_config_broadcast(self):
> +        """
> +        Dynamic config disable promiscuous, send a broadcast packet
> +        dpdk will received packet and fwd by io model. send a general
> packet
> +        and dst mac not port mac, dpdk will not received packet.
> +        """
> +
> +        self.dut.send_expect("set promisc all off", "testpmd> ")
> +        self.dut.send_expect("set fwd io", "testpmd> ")
> +        self.dut.send_expect("clear port stats all", "testpmd> ")
> +
> +
> self.dynamic_config_send_packet(self.dut_ports[0],"ff:ff:ff:ff:ff:ff")
> +        out = self.dut.send_expect(
> +            "show port stats %d" % self.dut_ports[1], "testpmd> ")
> +
> +        cur_rxpkt = dts.regexp(out, "TX-packets: ([0-9]+)")
> +        self.verify(int(cur_rxpkt) == 1, "1st packet increasment error")
> +
> +        self.dut.send_expect("clear port stats all", "testpmd> ")
> +
> +        self.dynamic_config_send_packet(self.dut_ports[0])
> +        out = self.dut.send_expect(
> +            "show port stats %d" % self.dut_ports[1], "testpmd> ")
> +
> +        cur_rxpkt = dts.regexp(out, "TX-packets: ([0-9]+)")
> +        self.verify(int(cur_rxpkt) == 0, "2st packet increasment error")
> +
> +    def test_dynamic_config_allmulticast(self):
> +        """
> +        Dynamic config disable promiscuous,when dpdk enable multicast,
> send a
> +        mulicast packet, dpdk received this packet and fwd by io model.
> when dpdk
> +        disable multicast, dpdk not received this packet
> +        """
> +
> +        self.dut.send_expect("set promisc all off", "testpmd> ")
> +        self.dut.send_expect("set fwd io", "testpmd> ")
> +        self.dut.send_expect("clear port stats all", "testpmd> ")
> +        self.dut.send_expect("set allmulti all on", "testpmd> ")
> +
> self.dynamic_config_send_packet(self.dut_ports[0],"01:00:00:33:00:01")
> +        out = self.dut.send_expect(
> +            "show port stats %d" % self.dut_ports[1], "testpmd> ")
> +
> +        cur_rxpkt = dts.regexp(out, "TX-packets: ([0-9]+)")
> +        self.verify(int(cur_rxpkt) == 1, "1st packet increasment error")
> +
> +        self.dut.send_expect("clear port stats all", "testpmd> ")
> +        self.dut.send_expect("set allmulti all off", "testpmd> ")
> +
> self.dynamic_config_send_packet(self.dut_ports[0],"01:00:00:33:00:01")
> +        out = self.dut.send_expect(
> +            "show port stats %d" % self.dut_ports[1], "testpmd> ")
> 
> +        cur_rxpkt = dts.regexp(out, "TX-packets: ([0-9]+)")
> +        self.verify(int(cur_rxpkt) == 0, "2st packet increasment error")
> +
>      def test_dynamic_config_enable_promiscuous(self):
>          """
>          Dynamic config enable promiscuous test
> --
> 1.9.3