[dts] [PATCH V1 1/2] add dyanmic config bonding rss hash test plan

[Xu, HuilongX]

Hi yong,
Some comments below

> -----Original Message-----
> From: Liu, Yong
> Sent: Wednesday, March 01, 2017 9:24 PM
> To: Xu, HuilongX; dts at dpdk.org
> Cc: Xu, HuilongX
> Subject: RE: [dts] [PATCH V1 1/2] add dyanmic config bonding rss hash test
> plan
> 
> Huilong,
> Some comments below.
> 
> Thanks,
> Marvin
> 
> > -----Original Message-----
> > From: dts [mailto:dts-bounces at dpdk.org] On Behalf Of xu,huilong
> > Sent: Wednesday, March 01, 2017 4:37 PM
> > To: dts at dpdk.org
> > Cc: Xu, HuilongX <huilongx.xu at intel.com>
> > Subject: [dts] [PATCH V1 1/2] add dyanmic config bonding rss hash test
> > plan
> >
> > Signed-off-by: xu,huilong <huilongx.xu at intel.com>
> > ---
> >  test_plans/pmdrss_hash_test_plan.rst | 24
> ++++++++++++++++++++++++
> >  1 file changed, 24 insertions(+)
> >
> > diff --git a/test_plans/pmdrss_hash_test_plan.rst
> > b/test_plans/pmdrss_hash_test_plan.rst
> > index 4922d3b..15e6b3b 100644
> > --- a/test_plans/pmdrss_hash_test_plan.rst
> > +++ b/test_plans/pmdrss_hash_test_plan.rst
> > @@ -150,3 +150,27 @@ Test Case:  test_simple_symmetric  The same as
> > the above two test cases. Just pay attention to set the hash function
> > to "simple xor"
> >
> >
> > +Test Case:  test_dyanmic_rss_bond_config
> > +=================================
> 
> Typo: should be dynamic_rss_bond_configt
Thanks  a lot, I will send V2 patch and fix it
> 
> > +This case test bond slaves will auto sync rss hash config, so it only
> > support fortville nic.
> > +
> > +#1. set up testpmd woth fortville NICs::
> > +./testpmd -c f -n 4 -- -i --portmask 0x3 --txqflags=0
> > +
> > +#2 creat bond device with mode 3::
> > + create bonded device 3 0
> > +#3 add slave to bond device::
> > + add bonding slave 0 2
> > + add bonding slave 1 2
> > +#4 get default hash algorithm on slave::
> > + get_hash_global_config 0
> > + get_hash_global_config 1
> > +#5 set hash algorithm on slave 0::
> > + set_hash_global_config 0 simple_xor ipv4-other  enable
> 
> Fortville not only support simple_xor, suggest test all kinds of hash algorithm
> supported by Fortville.
This case only test slave 1 will auto sync slave 0 hash function, and slave 0 and slave1 default hash function is  Toeplitz. So only change slave 0 used simple_xor, then slave 1 will
auto use simple_xor hash function replace Toeplitz hash function.
all hash algorithm and config will test in pmd_rsshash test suite. And 
It include simple_xor/simple_xor symmetry/ Toeplitz/ Toeplitz symmetry and different hash key. So not need test in this case.
> > +#6 get hash algorithm on slave 0 and 1::
> > + get_hash_global_config 0
> > + get_hash_global_config 1
> > +#7 check slave 0 and 1 use same hash algorithm
> > +
> > +
> > +
> > --
> > 1.9.3