[dts] FW: [PATCH V1] test_plans:add test plan about l2fwd_jobstats

[Wu, ChangqingX]

Hi

Could you ack this patch?

Thanks
changqingx

-----Original Message-----
From: Wu, ChangqingX 
Sent: Wednesday, April 3, 2019 2:37 PM
To: dts at dpdk.org
Cc: Wu, ChangqingX <changqingx.wu at intel.com>
Subject: [dts][PATCH V1] test_plans:add test plan about l2fwd_jobstats

Signed-off-by: changqingxwu <changqingx.wu at intel.com>
---
 test_plans/l2fwd_jobstats_test_plan.rst | 79 +++++++++++++++++++++++++
 1 file changed, 79 insertions(+)
 create mode 100644 test_plans/l2fwd_jobstats_test_plan.rst

diff --git a/test_plans/l2fwd_jobstats_test_plan.rst b/test_plans/l2fwd_jobstats_test_plan.rst
new file mode 100644
index 0000000..dbae2f1
--- /dev/null
+++ b/test_plans/l2fwd_jobstats_test_plan.rst
@@ -0,0 +1,79 @@
+.. Copyright (c) < 2019 >, Intel Corporation
+    All rights reserved.
+
+    Redistribution and use in source and binary forms, with or without
+    modification, are permitted provided that the following conditions
+    are met:
+
+    - Redistributions of source code must retain the above copyright
+        notice, this list of conditions and the following disclaimer.
+
+    - Redistributions in binary form must reproduce the above copyright
+        notice, this list of conditions and the following disclaimer in
+        the documentation and / or other materials provided with the
+        distribution.
+
+    - Neither the name of Intel Corporation nor the names of its
+        contributors may be used to endorse or promote products derived
+        from this software without specific prior written permission.
+
+    THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS
+    "AS IS" AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT
+    LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS
+    FOR A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE
+    COPYRIGHT OWNER OR CONTRIBUTORS BE LIABLE FOR ANY DIRECT, INDIRECT,
+    INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES
+    (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR
+     SERVICES
+     LOSS OF USE, DATA, OR PROFITS
+     OR BUSINESS INTERRUPTION)
+    HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT,
+    STRICT LIABILITY, OR TORT(INCLUDING NEGLIGENCE OR OTHERWISE)
+    ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED
+    OF THE POSSIBILITY OF SUCH DAMAGE.
+
+===================
+L2fwd Jobstats Test
+===================
+
+The L2 Forwarding sample application, which can operate in real and virtualized environments, performs L2 forwarding for each packet that is received. The destination port is the adjacent port from the enabled portmask, that is, if the first four ports are enabled (portmask 0x3), ports 0 and 1 forward into each other. Also, the MAC addresses are affected as follows:
+
+- The source MAC address is replaced by the TX port MAC address
+- The destination MAC address is replaced by 02:00:00:00:00:TX_PORT_ID
+
+Prerequisites
+=============
+
+If using vfio the kernel must be >= 3.6+ and VT-d must be enabled in 
+bios.When using vfio, use the following commands to load the vfio 
+driver and bind it to the device under test::
+
+    modprobe vfio
+    modprobe vfio-pci
+    usertools/dpdk-devbind.py --bind=vfio-pci device_bus_id
+
+The application requires a number of command line options::
+
+    ./build/l2fwd-jobstats [EAL options] -- -p PORTMASK [-q NQ] [-l]
+
+The ``l2fwd-jobstats`` application is run with EAL parameters and 
+parameters for the application itself. For details about the EAL 
+parameters, see the relevant DPDK **Getting Started Guide**. This 
+application supports three parameters for itself.
+
+- p PORTMASK: A hexadecimal bitmask of the ports to configure
+- q NQ: A number of queues (=ports) per lcore (default is 1)
+- l: Use locale thousands separator when formatting big numbers.
+
+Test Case: L2fwd jobstats check
+================================================
+
+Assume port 0 and 1 are connected to the traffic generator, to run the 
+test application in linuxapp environment with 2 ports and 2 RX queues 
+per lcore::
+
+    ./examples/l2fwd-jobstats/build/l2fwd-jobstats -c 0x03 -n 4  -- -q 
+ 2 -p 0x03 -l
+
+Then send 100, 000 packet to port 0 and 100, 000 packets to port 1, 
+check the NIC packets number reported by sample is the same with what 
+we set at the packet generator side.
--
2.17.2