[dts] [PATCH] dynamic add hardware requirement

[Lin, Xueqin]

My comment as below.

Best regards,
Xueqin

> -----Original Message-----
> From: dts [mailto:dts-bounces at dpdk.org] On Behalf Of xuyanjie
> Sent: Thursday, April 18, 2019 9:51 PM
> To: dts at dpdk.org
> Cc: Xu, Yanjie <yanjie.xu at intel.com>
> Subject: [dts] [PATCH] dynamic add hardware requirement
> 
> Signed-off-by: xuyanjie <yanjie.xu at intel.com>
> 
> diff --git a/test_plans/dynamic_config_test_plan.rst
> b/test_plans/dynamic_config_test_plan.rst
> index 4b6b1c7..38a7e83 100644
> --- a/test_plans/dynamic_config_test_plan.rst
> +++ b/test_plans/dynamic_config_test_plan.rst
> @@ -51,6 +51,10 @@ When promiscuous mode is disabled, packet must not
> be received. When  it is enabled, packets must be received. The change
> occurs without  stopping the device or restarting the application.
> 
> +Hardware
> +=============
> +
> +Any type NIC is supported

[Xueqin] The scope is too large, in /dpdk/drivers/net path, there are so many driver types, we may test this suite on e1000, ixgbe, i40e, not try all especially not try on some not-intel NICs.
"Any type NIC" is not make sense.  

> 
>  Prerequisites
>  =============
> --
> 2.7.4