[dts] [PATCH]test_plans: add a test case to TestSuite_vlan.py
Peng Yuan
yuan.peng at intel.com
Tue Jul 23 08:10:24 CEST 2019
add "Enable receipt of VLAN packets and disable VLAN header stripping" to TestSuite_vlan.py
Signed-off-by: Peng Yuan <yuan.peng at intel.com>
diff --git a/test_plans/vlan_test_plan.rst b/test_plans/vlan_test_plan.rst
index beaab9b..a5058f8 100644
--- a/test_plans/vlan_test_plan.rst
+++ b/test_plans/vlan_test_plan.rst
@@ -76,10 +76,10 @@ The -n command is used to select the number of memory channels. It should match
Set the verbose level to 1 to display information for each received packet::
testpmd> set verbose 1
+ testpmd> vlan set filter on
-
-Test Case: Enable receipt of VLAN packets and VLAN header stripping
-===================================================================
+Test Case: Enable receipt of VLAN packets and disable VLAN header stripping
+===========================================================================
Setup the ``mac`` forwarding mode::
@@ -89,6 +89,7 @@ Setup the ``mac`` forwarding mode::
Enable the receipt of VLAN packets with VLAN Tag Identifier 1 on port 0::
testpmd> rx_vlan add 1 0
+ testpmd> vlan set strip off 0
testpmd> start
rxonly packet forwarding - CRC stripping disabled - packets/burst=32
nb forwarding cores=1 - nb forwarding ports=10
@@ -108,6 +109,31 @@ Identifier and send 1 packet on port ``A``.
Verify that the VLAN packet was not correctly received on port ``B`` with
this not matched VLAN Tag.
+Test Case: Enable receipt of VLAN packets and VLAN header stripping
+===================================================================
+
+Setup the ``mac`` forwarding mode::
+
+ testpmd> set fwd mac
+ Set mac packet forwarding mode
+
+Enable the receipt of VLAN packets with VLAN Tag Identifier 1 on port 0::
+
+ testpmd> rx_vlan add 1 0
+ testpmd> vlan set strip on 0
+ testpmd> start
+ rxonly packet forwarding - CRC stripping disabled - packets/burst=32
+ nb forwarding cores=1 - nb forwarding ports=10
+ RX queues=1 - RX desc=128 - RX free threshold=64
+ RX threshold registers: pthresh=8 hthresh=8 wthresh=4
+ TX queues=1 - TX desc=512 - TX free threshold=0
+ TX threshold registers: pthresh=32 hthresh=8 wthresh=8
+
+Configure the traffic generator to send VLAN packets with the Tag Identifier
+ ``1`` and send 1 packet on port ``A``.
+
+Verify that the VLAN packet was correctly received on port ``B`` without VLAN tag ``1``.
+
Test Case: Disable receipt of VLAN packets
==========================================
--
2.14.3
More information about the dts
mailing list