[dts] [PATCH V1] increase send packet number when bonding mode is 5

[Wu, ChangqingX]

Tested-by: Wu, ChangqingX <changqingx.wu at intel.com>

-----Original Message-----
From: dts [mailto:dts-bounces at dpdk.org] On Behalf Of lihong
Sent: Tuesday, May 7, 2019 8:31 AM
To: dts at dpdk.org
Cc: Ma, LihongX <lihongx.ma at intel.com>
Subject: [dts] [PATCH V1] increase send packet number when bonding mode is 5

when bonding mode is 5, the transmit should load balancing for tx, if receive packet number not enough, it will not reflect the balance state. So change the send packet number from 1000 to 100000.

Signed-off-by: lihong <lihongx.ma at intel.com>
---
 tests/TestSuite_pmd_bonded.py | 6 +++---
 1 file changed, 3 insertions(+), 3 deletions(-)

diff --git a/tests/TestSuite_pmd_bonded.py b/tests/TestSuite_pmd_bonded.py index 2d4856a..78d5d21 100644
--- a/tests/TestSuite_pmd_bonded.py
+++ b/tests/TestSuite_pmd_bonded.py
@@ -196,7 +196,7 @@ class TestPmdBonded(TestCase):
         """
         Send count packet to portid
         count: 1 or 2 or 3 or ... or 'MANY'
-               if count is 'MANY', then set count=1000,
+               if count is 'MANY', then set count=100000,
                send packets during 5 seconds.
         ether_ip:
             'ether':
@@ -226,7 +226,7 @@ class TestPmdBonded(TestCase):
         except ValueError as e:
             if count == 'MANY':
                 during = 5
-                count = 1000
+                count = 100000
             else:
                 raise e
 
@@ -261,7 +261,7 @@ UDP(sport=srcport, dport=destport)/Raw(load="\x50"*%s)], iface="%s", count=%d)'
                 self.tester.scapy_append('sendp([Ether(dst=nutmac, src=srcmac)/Dot1Q(vlan=vlanvalue)/IP(dst=destip, src=srcip, len=%s)/\  UDP(sport=srcport, dport=destport)/Raw(load="\x50"*%s)], iface="%s", count=%d)' % (pktlen, padding, itf, count))
 
-            self.tester.scapy_execute()
+            self.tester.scapy_execute(timeout=180)
             loop += 1
 
             now = time.time()
--
2.7.4