[dts] [PATCH v1]test_plans: add two nic type to ipgre_test_plan.rst

[Tu, Lijuan]

Applied, thanks

> -----Original Message-----
> From: dts [mailto:dts-bounces at dpdk.org] On Behalf Of Peng Yuan
> Sent: Monday, September 23, 2019 5:24 PM
> To: dts at dpdk.org
> Cc: Peng, Yuan <yuan.peng at intel.com>
> Subject: [dts] [PATCH v1]test_plans: add two nic type to ipgre_test_plan.rst
> 
> Add two nic types to ipgre_test_plan.rst
> 
> Signed-off-by: Peng Yuan <yuan.peng at intel.com>
> 
> diff --git a/test_plans/ipgre_test_plan.rst b/test_plans/ipgre_test_plan.rst
> index 97c4a51..c7ab602 100644
> --- a/test_plans/ipgre_test_plan.rst
> +++ b/test_plans/ipgre_test_plan.rst
> @@ -41,14 +41,14 @@ Fortville support GRE packet detecting, checksum
> computing and filtering.
>  Prerequisites
>  =============
> 
> -Fortville nic should be on the DUT.
> +Fortville/carlsville/columbiaville nic should be on the DUT.
> 
>  Test Case 1: GRE ipv4 packet detect
>  ===================================
> 
>  Start testpmd and enable rxonly forwarding mode::
> 
> -    testpmd -c ffff -n 4 -- -i --tx-offloads=0x8fff
> +    testpmd -c ffff -n 4 -- -i
>      testpmd> set fwd rxonly
>      testpmd> set verbose 1
>      testpmd> start
> @@ -77,7 +77,7 @@ Test Case 2: GRE ipv6 packet detect
> 
>  Start testpmd and enable rxonly forwarding mode::
> 
> -    testpmd -c ffff -n 4 -- -i --tx-offloads=0x8fff
> +    testpmd -c ffff -n 4 -- -i --enable-hw-vlan
>      testpmd> set fwd rxonly
>      testpmd> set verbose 1
>      testpmd> start
> @@ -124,7 +124,7 @@ Test Case 3: GRE packet filter
> 
>  Start testpmd with multi queues::
> 
> -    testpmd -c ff -n 3 -- -i  --rxq=4 --txq=4 --tx-offloads=0x8fff
> +    testpmd -c ff -n 3 -- -i  --rxq=4 --txq=4
>      testpmd> set fwd rxonly
>      testpmd> set nbcore 4
>      testpmd> set verbose 1
> @@ -161,7 +161,7 @@ Test Case 4: GRE packet chksum offload
> 
>  Start testpmd with hardware checksum offload enabled::
> 
> -    testpmd -c ff -n 3 -- -i --tx-offloads=0x8fff --enable-rx-cksum  --port-
> topology=loop
> +    testpmd -c ff -n 3 -- -i --enable-rx-cksum  --port-topology=loop
>      testpmd> set verbose 1
>      testpmd> set fwd csum
>      testpmd> csum set ip hw 0
> --
> 2.7.4