[dts] [PATCH]test_plans: correct typo errors
Tu, Lijuan
lijuan.tu at intel.com
Tue Feb 18 08:06:24 CET 2020
Applied,thanks
> -----Original Message-----
> From: dts [mailto:dts-bounces at dpdk.org] On Behalf Of Peng Yuan
> Sent: Tuesday, February 18, 2020 11:20 AM
> To: dts at dpdk.org
> Cc: Peng, Yuan <yuan.peng at intel.com>
> Subject: [dts] [PATCH]test_plans: correct typo errors
>
> correct typo errors in qos_sched_test_plan.rst, and remove two subports
> cases.
>
> Signed-off-by: Peng Yuan <yuan.peng at intel.com>
>
> diff --git a/test_plans/qos_sched_test_plan.rst
> b/test_plans/qos_sched_test_plan.rst
> index 8675406..0340eee 100644
> --- a/test_plans/qos_sched_test_plan.rst
> +++ b/test_plans/qos_sched_test_plan.rst
> @@ -308,7 +308,7 @@ Test Case: best effort TC12
>
> 2. The traffic manage setting is configured in profile.cfg.
> Set flows with QinQ inner vlan ID=0, which represents pipe 0.
> - Set IP dst address from 10.0.0.12~10.0.0.4, which enter queue12~queue14,
> + Set IP dst address from 10.0.0.12~10.0.0.14, which enter
> + queue12~queue14,
> mapping TC12.
> Frame size=70bytes.
> Send rate is 100% linerate.
> @@ -591,6 +591,9 @@ the default mastercore 1 and the RX, WT and TX
> cores only.
>
> Test Case: Two Subports, different pipe profiles, different number of pipes I
> ================================================================
> =============
> +*Note: the sample can't be set to two subports, so the two supports
> +case can't be verified.*
> +
> 1. Configure the profile.cfg file with two subports, two different pipe
> profiles and different number of pipes::
>
> @@ -636,6 +639,9 @@ Test Case: Two Subports, different pipe profiles,
> different number of pipes I
>
> Test Case: Two Subports, different pipe profiles, different number of pipes II
> ================================================================
> ==============
> +*Note: the sample can't be set to two subports, so the two supports
> +case can't be verified.*
> +
> 1. Configure the profile.cfg file the same with last case I.
>
> 2. This example uses a single packet flow configuration @@ -666,7 +672,7
> @@ Test Case: Redistribution of unused pipe BW to other pipes within the
> same subpo
> which creates one RX thread on lcore 5 reading from port 0
> and a worker thread on lcore 7 writing to port 1::
>
> - ./qos_sched -l 1,2,5,7 -n 4 -- -i --pfc "0,1,2,5,7" --cfg ../profile.cfg
> + ./qos_sched -l 1,2,5,7 -n 4 -- -i --pfc "0,1,2,5,7" --cfg
> + ../profile_ov.cfg
>
> 3. The generator settings:
> Configure 4 flows:
> --
> 2.7.4
More information about the dts
mailing list