[PATCH 7/9] net/ngbe: fix issues caused by MNG veto bit setting

[Jiawen Wu]

In the new firmware, MNG veto bit is set by default for new features. It
causes the PHY configuration not to be reset after LAN reset. So PHY power
will be down after stopping device. The internal PHY then cannot be
initialized successfully at device start. Add setting power on for internal
PHY to fix this issue.

Fixes: abea8974c7a6 ("net/ngbe: support link down/up")
Cc: stable at dpdk.org

Signed-off-by: Jiawen Wu <jiawenwu at trustnetic.com>
---
 drivers/net/ngbe/base/ngbe_phy_rtl.c | 2 ++
 1 file changed, 2 insertions(+)

diff --git a/drivers/net/ngbe/base/ngbe_phy_rtl.c b/drivers/net/ngbe/base/ngbe_phy_rtl.c
index 9b323624ec..88bacec114 100644
--- a/drivers/net/ngbe/base/ngbe_phy_rtl.c
+++ b/drivers/net/ngbe/base/ngbe_phy_rtl.c
@@ -120,6 +120,8 @@ s32 ngbe_init_phy_rtl(struct ngbe_hw *hw)
 	hw->init_phy = true;
 	msec_delay(1);
 
+	hw->phy.set_phy_power(hw, true);
+
 	for (i = 0; i < 15; i++) {
 		if (!rd32m(hw, NGBE_STAT,
 			NGBE_STAT_GPHY_IN_RST(hw->bus.lan_id)))
-- 
2.27.0