[dpdk-users] Issue on Running KNI application

[P D, Arun (Nokia - IN/Bangalore)]

Hello,

I am trying to run the KNI program in examples of dpdk.

I am giving the following command and facing the error as  "Cause: lcore id 1 for port 0 receiving not enabled".

Please let me know if I am making any mistake at config parameters, or I am missing something.

./kni -c 4 -n 4 -- -P -p 0x3 --config="(0,1,3),(1,2,4)"

EAL: Detected lcore 0 as core 0 on socket 0
EAL: Detected lcore 1 as core 1 on socket 0
EAL: Detected lcore 2 as core 2 on socket 0
EAL: Detected lcore 3 as core 3 on socket 0
EAL: Support maximum 128 logical core(s) by configuration.
EAL: Detected 4 lcore(s)
EAL: Setting up physically contiguous memory...
EAL: Ask a virtual area of 0x200000 bytes
EAL: Virtual area found at 0x7fd603600000 (size = 0x200000)
EAL: Ask a virtual area of 0x1000000 bytes
EAL: Virtual area found at 0x7fd602400000 (size = 0x1000000)
EAL: Ask a virtual area of 0x3c00000 bytes
EAL: Virtual area found at 0x7fd5fe600000 (size = 0x3c00000)
EAL: Ask a virtual area of 0x50400000 bytes
EAL: Virtual area found at 0x7fd5ae000000 (size = 0x50400000)
EAL: Ask a virtual area of 0x29c00000 bytes
EAL: Virtual area found at 0x7fd584200000 (size = 0x29c00000)
EAL: Ask a virtual area of 0x1000000 bytes
EAL: Virtual area found at 0x7fd583000000 (size = 0x1000000)
EAL: Ask a virtual area of 0x200000 bytes
EAL: Virtual area found at 0x7fd582c00000 (size = 0x200000)
EAL: Requesting 1024 pages of size 2MB from socket 0
EAL: TSC frequency is ~3192614 KHz
EAL: Master lcore 2 is ready (tid=3cb98e0;cpuset=[2])
EAL: PCI device 0000:03:00.0 on NUMA socket -1
EAL:   probe driver: 8086:1533 rte_igb_pmd
EAL:   Not managed by a supported kernel driver, skipped
EAL: PCI device 0000:05:00.0 on NUMA socket -1
EAL:   probe driver: 8086:100e rte_em_pmd
EAL:   Not managed by a supported kernel driver, skipped
EAL: PCI device 0000:06:00.0 on NUMA socket -1
EAL:   probe driver: 8086:10d3 rte_em_pmd
EAL:   Not managed by a supported kernel driver, skipped
APP: Port ID: 0
APP: Rx lcore ID: 1, Tx lcore ID: 3
APP: Port ID: 1
APP: Rx lcore ID: 2, Tx lcore ID: 4
EAL: Error - exiting with code: 1
  Cause: lcore id 1 for port 0 receiving not enabled

Regards,
Arun Raj