[dpdk-dev,18/61] net/qede/base: remove unneeded step in HW init
Checks
Commit Message
There is no need to close the OUT_EN NIG registers, so remove that.
Signed-off-by: Rasesh Mody <rasesh.mody@cavium.com>
---
drivers/net/qede/base/ecore_dev.c | 12 ------------
1 file changed, 12 deletions(-)
@@ -1007,18 +1007,6 @@ static enum _ecore_status_t ecore_hw_init_common(struct ecore_hwfn *p_hwfn,
ecore_cxt_hw_init_common(p_hwfn);
- /* Close gate from NIG to BRB/Storm; By default they are open, but
- * we close them to prevent NIG from passing data to reset blocks.
- * Should have been done in the ENGINE phase, but init-tool lacks
- * proper port-pretend capabilities.
- */
- ecore_wr(p_hwfn, p_ptt, NIG_REG_RX_BRB_OUT_EN, 0);
- ecore_wr(p_hwfn, p_ptt, NIG_REG_STORM_OUT_EN, 0);
- ecore_port_pretend(p_hwfn, p_ptt, p_hwfn->port_id ^ 1);
- ecore_wr(p_hwfn, p_ptt, NIG_REG_RX_BRB_OUT_EN, 0);
- ecore_wr(p_hwfn, p_ptt, NIG_REG_STORM_OUT_EN, 0);
- ecore_port_unpretend(p_hwfn, p_ptt);
-
rc = ecore_init_run(p_hwfn, p_ptt, PHASE_ENGINE, ANY_PHASE_ID, hw_mode);
if (rc != ECORE_SUCCESS)
return rc;