[dpdk-dev] app/testpmd:vlan filter fail
Checks
Commit Message
Hi,
Thanks for your review. I got it!
Yanglong Wu
-----Original Message-----
From: Shahaf Shuler [mailto:shahafs@mellanox.com]
Sent: Sunday, February 4, 2018 2:27 PM
To: Wu, Yanglong <yanglong.wu@intel.com>; dev@dpdk.org
Cc: Lu, Wenzhuo <wenzhuo.lu@intel.com>
Subject: RE: [PATCH] app/testpmd:vlan filter fail
Hi Wu,
Indeed there is an issue here, but this is not the right fix.
Friday, February 2, 2018 7:10 AM, Yanglong Wu:
> Subject: [PATCH] app/testpmd:vlan filter fail
>
> Removing out port_conf.rxmode.hw_vlan_filter = 1 will let it equal to
> 0 and port_conf.rxmode.offloads is assigned as 0 again if
> hw_vlan_filter = 1. So it will always lead to fail for vlan filter
> setting
>
> Fix:0074d02fc(convert to new Rx offloads API)
> Signed-off-by: Yanglong Wu <yanglong.wu@intel.com>
> ---
> app/test-pmd/testpmd.c | 2 +-
> 1 file changed, 1 insertion(+), 1 deletion(-)
>
> diff --git a/app/test-pmd/testpmd.c b/app/test-pmd/testpmd.c index
> 5dc8ccac5..0751e573c 100644
> --- a/app/test-pmd/testpmd.c
> +++ b/app/test-pmd/testpmd.c
> @@ -2328,7 +2328,7 @@ init_port_dcb_config(portid_t pid,
> retval = get_eth_dcb_conf(&port_conf, dcb_mode, num_tcs, pfc_en);
> if (retval < 0)
> return retval;
> - port_conf.rxmode.offloads |= DEV_RX_OFFLOAD_VLAN_FILTER;
> + port_conf.rxmode.hw_vlan_filter = 1;
The VLAN filter resets because the rxmode.ignore_offload_bitfield is not set. If it was set, the ethdev rxmode convert functions would have convert the new flag to the old API (rxmode.hw_vlan_filter).
Am not much familiar with this configuration but here is a suggested fix:
The port_conf for the dcb configuration will inherit the same configuration of the port (which has the ignore_offload_bitfield set).
Otherwise, at least the rxmode.ignore_offload_bitfield must be set.
>
> /**
> * Write the configuration into the device.
> --
> 2.11.0
@@ -2324,6 +2324,8 @@ init_port_dcb_config(portid_t pid,
rte_port = &ports[pid];
memset(&port_conf, 0, sizeof(struct rte_eth_conf));
+ port_conf.rxmode = rte_port->dev_conf.rxmode;
+ port_conf.txmode = rte_port->dev_conf.txmode;
/* Enter DCB configuration status */
dcb_config = 1;