[RFC] net/mlx5: support e-switch TCP-flags flow filter
Checks
Commit Message
Today, it is possible to offload an interface flow rules to the hardware
using DPDK flow commands.
With mlx5 it is also possible to offload a limited set of flow rules to
the mlxsw (or e-switch) using the same DPDK flow commands.
A 'transfer' attribute was added to the flow rule creation command in
order to distinguish between configuring port flows and E-switch flows.
The commands destined for the switch are transposed to TC flower rules
and are send, as Netlink messages, to the mlx5 driver, or more precisely
to the netdev which represent the mlxsw port.
The limited set of e-switch flow rules also supports filtering according
to the values found in the TCP flags. but the mlx5 PMD does not
implement this filter.
The purpose of this RFC is to propose an enhancement to the e-switch
flow filtering rules to also include filtering according to the TCP
flags.
Below is the propose enhancement.
NOTE:
This code is supposed to be applied on top of the flow steering
rework not committed yet and therefore may be subject to changes.
Signed-off-by: Moti Haimovsky <motih@mellanox.com>
---
drivers/net/mlx5/Makefile | 10 ++++++++++
drivers/net/mlx5/mlx5_nl_flow.c | 20 +++++++++++++++++++-
2 files changed, 29 insertions(+), 1 deletion(-)
@@ -335,6 +335,16 @@ mlx5_autoconf.h.new: $(RTE_SDK)/buildtools/auto-config-h.sh
enum TCA_FLOWER_KEY_VLAN_ETH_TYPE \
$(AUTOCONF_OUTPUT)
$Q sh -- '$<' '$@' \
+ HAVE_TCA_FLOWER_KEY_TCP_FLAGS \
+ linux/pkt_cls.h \
+ enum TCA_FLOWER_KEY_TCP_FLAGS \
+ $(AUTOCONF_OUTPUT)
+ $Q sh -- '$<' '$@' \
+ HAVE_TCA_FLOWER_KEY_TCP_FLAGS_MASK \
+ linux/pkt_cls.h \
+ enum TCA_FLOWER_KEY_TCP_FLAGS_MASK \
+ $(AUTOCONF_OUTPUT)
+ $Q sh -- '$<' '$@' \
HAVE_TC_ACT_VLAN \
linux/tc_act/tc_vlan.h \
enum TCA_VLAN_PUSH_VLAN_PRIORITY \
@@ -146,6 +146,12 @@ struct tc_vlan {
#ifndef HAVE_TCA_FLOWER_KEY_VLAN_ETH_TYPE
#define TCA_FLOWER_KEY_VLAN_ETH_TYPE 25
#endif
+#ifndef TCA_FLOWER_KEY_TCP_FLAGS
+#define TCA_FLOWER_KEY_TCP_FLAGS 71
+#endif
+#ifndef TCA_FLOWER_KEY_TCP_FLAGS_MASK
+#define TCA_FLOWER_KEY_TCP_FLAGS_MASK 72
+#endif
/** Parser state definitions for mlx5_nl_flow_trans[]. */
enum mlx5_nl_flow_trans {
@@ -258,6 +264,7 @@ enum mlx5_nl_flow_trans {
.tcp.hdr = {
.src_port = RTE_BE16(0xffff),
.dst_port = RTE_BE16(0xffff),
+ .tcp_flags = 0xff,
},
.udp.hdr = {
.src_port = RTE_BE16(0xffff),
@@ -812,7 +819,18 @@ enum mlx5_nl_flow_trans {
spec.tcp->hdr.dst_port) ||
!mnl_attr_put_u16_check(buf, size,
TCA_FLOWER_KEY_TCP_DST_MASK,
- mask.tcp->hdr.dst_port))))
+ mask.tcp->hdr.dst_port))) ||
+ (mask.tcp->hdr.tcp_flags &&
+ (!mnl_attr_put_u16_check
+ (buf, size,
+ TCA_FLOWER_KEY_TCP_FLAGS,
+ rte_cpu_to_be_16
+ (spec.tcp->hdr.tcp_flags)) ||
+ !mnl_attr_put_u16_check
+ (buf, size,
+ TCA_FLOWER_KEY_TCP_FLAGS_MASK,
+ rte_cpu_to_be_16
+ (mask.tcp->hdr.tcp_flags)))))
goto error_nobufs;
++item;
break;