[v2] net/tap: Allow all-zero checksum for UDP over IPv4
Checks
Commit Message
Unlike TCP, UDP checksums are optional and may be zero to indicate "not
set" [RFC 768] (except for IPv6, where this prohibited [RFC 8200]). Add
this special case to the checksum offload emulation in net/tap.
Signed-off-by: Michael Pfeiffer <michael.pfeiffer@tu-ilmenau.de>
---
v2:
* Added comment.
drivers/net/tap/rte_eth_tap.c | 18 ++++++++++++++++--
1 file changed, 16 insertions(+), 2 deletions(-)
Comments
On 11/13/2020 2:03 PM, Michael Pfeiffer wrote:
> Unlike TCP, UDP checksums are optional and may be zero to indicate "not
> set" [RFC 768] (except for IPv6, where this prohibited [RFC 8200]). Add
> this special case to the checksum offload emulation in net/tap.
>
> Signed-off-by: Michael Pfeiffer <michael.pfeiffer@tu-ilmenau.de>
Reviewed-by: Ferruh Yigit <ferruh.yigit@intel.com>
Applied to dpdk-next-net/main, thanks.
@@ -303,6 +303,7 @@ tap_verify_csum(struct rte_mbuf *mbuf)
uint16_t cksum = 0;
void *l3_hdr;
void *l4_hdr;
+ struct rte_udp_hdr *udp_hdr;
if (l2 == RTE_PTYPE_L2_ETHER_VLAN)
l2_len += 4;
@@ -349,10 +350,23 @@ tap_verify_csum(struct rte_mbuf *mbuf)
/* Don't verify checksum for multi-segment packets. */
if (mbuf->nb_segs > 1)
return;
- if (l3 == RTE_PTYPE_L3_IPV4)
+ if (l3 == RTE_PTYPE_L3_IPV4) {
+ if (l4 == RTE_PTYPE_L4_UDP) {
+ udp_hdr = (struct rte_udp_hdr *)l4_hdr;
+ if (udp_hdr->dgram_cksum == 0) {
+ /*
+ * For IPv4, a zero UDP checksum
+ * indicates that the sender did not
+ * generate one [RFC 768].
+ */
+ mbuf->ol_flags |= PKT_RX_L4_CKSUM_NONE;
+ return;
+ }
+ }
cksum = ~rte_ipv4_udptcp_cksum(l3_hdr, l4_hdr);
- else if (l3 == RTE_PTYPE_L3_IPV6)
+ } else if (l3 == RTE_PTYPE_L3_IPV6) {
cksum = ~rte_ipv6_udptcp_cksum(l3_hdr, l4_hdr);
+ }
mbuf->ol_flags |= cksum ?
PKT_RX_L4_CKSUM_BAD :
PKT_RX_L4_CKSUM_GOOD;