[dpdk-dev] [PATCH 3/3] net/netvsc: add hyper-v netvsc network device
Stephen Hemminger
stephen at networkplumber.org
Thu Apr 5 22:59:46 CEST 2018
On Thu, 05 Apr 2018 22:52:31 +0200
Thomas Monjalon <thomas at monjalon.net> wrote:
> Hi Stephen,
>
> Good to see there is a good progress.
>
> This patch should add an entry in the release notes.
> But I guess it is not ready for 18.05?
>
>
> 05/04/2018 21:13, Stephen Hemminger:
> > +#
> > +# Compile native PMD for Hyper-V/Azure
> > +#
> > +CONFIG_RTE_LIBRTE_NETVSC_PMD=n
> > +CONFIG_RTE_LIBRTE_NETVSC_DEBUG_RX=n
> > +CONFIG_RTE_LIBRTE_NETVSC_DEBUG_TX=n
> > +CONFIG_RTE_LIBRTE_NETVSC_DEBUG_DUMP=n
>
> Please switch to the new dynamic logging.
It does use dynamic logging for the normal driver logs. For debug the dump
code is a config option (same as other current drivers).
>
>
> [...]
> > +the Data Plane Development Kit (DPDK), we provide a Netwwork Virtual
>
> typo: Netwwork
>
>
> > +The following prerequisites apply:
> > +
> > +* Linux kernel uio_hv_generic driver that supports subchannels. This should be present in 4.17 or later.
>
> The DPDK policy is to wait for prerequisite be available for merging.
Does linux-next count?
>
>
> > --- a/drivers/net/Makefile
> > +++ b/drivers/net/Makefile
> > @@ -46,6 +46,7 @@ DIRS-$(CONFIG_RTE_LIBRTE_THUNDERX_NICVF_PMD) += thunderx
> > DIRS-$(CONFIG_RTE_LIBRTE_VDEV_NETVSC_PMD) += vdev_netvsc
> > DIRS-$(CONFIG_RTE_LIBRTE_VIRTIO_PMD) += virtio
> > DIRS-$(CONFIG_RTE_LIBRTE_VMXNET3_PMD) += vmxnet3
> > +DIRS-$(CONFIG_RTE_LIBRTE_NETVSC_PMD) += netvsc
>
> Please keep the alphabetical order.
Ok
More information about the dev
mailing list