[PATCH V2 1/4] net/bonding: fix non-active slaves aren't stopped

[Min Hu (Connor)]

From: Huisong Li <lihuisong at huawei.com>

When stopping a bonded port, all slaves should be deactivated. But only
active slaves are stopped. So fix it and do "deactivae_slave()" for active
slaves.

Fixes: 0911d4ec0183 ("net/bonding: fix crash when stopping mode 4 port")
Cc: stable at dpdk.org

Signed-off-by: Huisong Li <lihuisong at huawei.com>
Signed-off-by: Min Hu (Connor) <humin29 at huawei.com>
---
 drivers/net/bonding/rte_eth_bond_pmd.c | 20 +++++++++++---------
 1 file changed, 11 insertions(+), 9 deletions(-)

diff --git a/drivers/net/bonding/rte_eth_bond_pmd.c b/drivers/net/bonding/rte_eth_bond_pmd.c
index b305b6a35b..469dc71170 100644
--- a/drivers/net/bonding/rte_eth_bond_pmd.c
+++ b/drivers/net/bonding/rte_eth_bond_pmd.c
@@ -2118,18 +2118,20 @@ bond_ethdev_stop(struct rte_eth_dev *eth_dev)
 	internals->link_status_polling_enabled = 0;
 	for (i = 0; i < internals->slave_count; i++) {
 		uint16_t slave_id = internals->slaves[i].port_id;
+
+		internals->slaves[i].last_link_status = 0;
+		ret = rte_eth_dev_stop(slave_id);
+		if (ret != 0) {
+			RTE_BOND_LOG(ERR, "Failed to stop device on port %u",
+				     slave_id);
+			return ret;
+		}
+
+		/* active slaves need to deactivate. */
 		if (find_slave_by_id(internals->active_slaves,
 				internals->active_slave_count, slave_id) !=
-						internals->active_slave_count) {
-			internals->slaves[i].last_link_status = 0;
-			ret = rte_eth_dev_stop(slave_id);
-			if (ret != 0) {
-				RTE_BOND_LOG(ERR, "Failed to stop device on port %u",
-					     slave_id);
-				return ret;
-			}
+				internals->active_slave_count)
 			deactivate_slave(eth_dev, slave_id);
-		}
 	}
 
 	return 0;
-- 
2.33.0